Installation Instructions | XSM/XTM Series |
3d |
3e |
Knobs to outside |
of brackets |
Center Line (CL)
Pull strap
NEVER place both interface brackets to one side of the wall mount center line (CL)!
Figure 6
Attaching Screen to Wall Mount
1.Attach wall bracket caps (H) to top and bottom of both wall brackets. (See Figure 7)
(H) x 4 |
Figure 7
2.Adjust Velcro® pull strap (if necessary) so it does not extend beyond bottom of screen. (See Figure 8)
NOTE: NEVER place both interface brackets to one side of the wall mount center line! (See Figure 8)
NOTE: Do NOT allow both interface brackets to be located on same side of wall bracket. (See Figure 8)
Both interface brackets must NEVER be located to one side of the wall brackets!
Figure 8
XTM Model
NOTE: Proceed to Step 8 for XSM Model instructions.
3.Hang top hook of interface brackets onto the top bar of the mount. (See Figure 9)
NOTE: The screen initially installs into the "kickstand mode" to allow easy cable access.
4.Slide screen and bars to desired viewing position.
5.Route cables between wall and bars.
CAUTION: PINCH POINTS! Keep fingers, hands and cables out of pinch point areas.
6.Pull downward on the pullstraps and swing inward toward wall, latching interface brackets to lower bar and locking bottom of screen to the mount. (See Figure 9)
9