Model: MWC Series | Installation Instructions |
INSTALLATION
MOUNT INSTALLATION
Three installation options exist:
•Dual Wood Stud (16"
•Dual Steel Stud (requires Chief
•Drywall (1/2" minimum; requires Chief
The following instructions are for dual wood stud
CPU INSTALLATION
WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the MWC Series Wall Mount, including the CPU and display, does not exceed 100 lbs (45 kg).
1.Using key (60) remove and retain upper front plate attach screws and washers (See Figure 3).
installation. See instructions included with
1.Determine approximate mounting location, keeping in mind the display size.
2.Use a stud sensor to locate applicable wood studs. Mark locations with a pencil.
3.Level mount at desired height. Using mount as a template, mark the location of four pilot holes. Ensure marks are in the center of wood studs.
4.Drill pilot holes using a 7/32" drill bit. Ensure pilot holes are straight.
5.Using 1/2" wrench, install four 5/16" x
NOTE: Drywall not |
shown for clarity. |
Side Plates |
NOTE: Lower front plate attach screws may remain installed.
Front | Upper front plate |
Plate | attach screws and |
| washers (2 places) |
Figure 3: Upper Front Plate Attach Screws
2.Tilt front plate away from wall and then lift out of lower front plate attach screws (See Figure 4). Place front plate on protective surface.
(80) x 4 |
(70) x 4 |
Figure 2: Mount Installation
2
1
Front Plate
Lower front plate attach screws
(2 places)
Figure 4: Remove Front Plate
3.Loosely thread strap (20) through side plates so that buckle is in front (See Figure 5).
4