Attaching Interface Brackets to TV

MSM/MTM Series

Installation Instructions

8.Mark the attachment points for the lower mounting slots. (See Figure 4)

9.Drill one pilot hole at each marking for lower mounting holes. (See Figure 4)

10.Install an anchor (K1) into each pilot hole using a hammer.

11.Use two 5/16 x 2-1/2" lag bolts (K3) and two 5/16" flat washers (K2) to attach the mount to the wall through the lower mounting holes. (See Figure 4)

12.Slide rails to approximate center of screen location.

1.Align the center of the bracket with center of screen. (See Figure 5)

NOTE: The diamond-shape hole in the bracket corresponds to the center of the mount.

Pull strap

Center of bracket

Figure 5

WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display. Properly sized screws will easily and completely thread into display mounting holes. If spacers are required, be sure to use longer screws of the same diameter.

2.Select correct screws, spacers (if necessary) and washers from the hardware bag and attach brackets to back of screen. (See Figure 5)

Switching Interface Brackets (Optional)

If an installation situation makes adjusting the location of interface brackets necessary, there are several options.

1.The wall bracket may be adjusted side to side at the point of attachment (mounting slots for dual stud installation, mounting holes for single stud installation). (See Figure )

2.The location of the left and right interface brackets may be switched, with the knobs on the MTM interface brackets facing the inside of the mount. (See Figure )

	Mounting
	Holes
Mounting	1
Slot	1
	Knobs
	2

Figure 6