Chief Manufacturing MSS6000 Adjustments, Display Roll Adjustment, Display Height Adjustment

Installation Instructions				MSS6000
1	Remove bolt
	or padlock	2		Height Adjustment
	if used		5" Max.
				Screws
				(2 each side)
Pin in
"Closed"
position -
move to
"Open"
position to
remove
display
	4
			Figure 8
		Display Roll Adjustment
Pin in		The MSS-6000 provides limited display roll adjustment
		for the purpose of leveling the display.
"Open"		To level the display:
position -
move to		1.	Loosen upper and lower roll adjustment nuts.
"Closed"
			(See Figure 9)
position
		2.	Level display. (See Figure 9)
after display
is removed.		3.	Tighten roll adjustment nuts.

Figure 7

ADJUSTMENTS

Display Height Adjustment

CAUTION: Displays are fragile. Allowing the display to drop to bottom of stand may result in damage to the display.

1.While holding the display, loosen the four height adjustment screws. (See Figure 8)

CAUTION: Make sure all cables and wires are not pinched when raising or lowering display.

2.Position display at the desired height.

3.Tighten four height adjustment screws. (See Figure 8)

7