4.OPERATING INSTRUCTIONS
Configuring the Starting Address
The Intimidator™ Scan LED 100 fixture uses 6 DMX channels. In this DMX configuration/personality, the highest channel that the fixture may be set to in order to function properly is 507. Any address higher than this will prevent access to all of the channels, while in this mode; however, if you desire to use one of the other DMX channels configurations (personalities), please consider the total DMX channels when selecting a DMX address.
If this is your first time using DMX, we recommend reading the “DMX Primer” section in the “Appendix”.
Operation
DMX Operation
This is the operating mode which will allow for control with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual.
1.Plug a DMX controller into the fixture in a daisy chain configuration.
2.Using the DIP switches, select the starting address (001~507).
Only connect 32 fixtures to a single DMX daisy chain!
Master/Slave Mode (Sound-Active, Auto Mode)
This mode allows a single unit, the master, to operate in one of the standalone modes, while one or more fixtures, slaves, synchronize their responses to the master.
Master:
The master fixture may be set in any of the STANDALONE modes listed in this user manual.
This must be placed first in the DMX daisy chain.
Slave:
1.Turn off all DIP switches and daisy chain from the output of the master.
Only connect 31 slave fixtures when operating in this mode!
4. Operating Instructions | 8 | 11/19/2010 11:07 AM |