Samsung VC7726VC4R/RAD manual Using the Mite Killer Optional

Page 5

DJ68-00079P(0.0) 4/23/02 8:54 PM Page 5

USING THE BLOWER (EXCEPT HANDLE CONTROL TYPE)

To blow out dust in crevices or corners you can use this function for your convenience.

Located on the rear side of the cleaner.

1)Disconnect the hose clamper from the body of the cleaner.

2) Open the tool storage cover.

3)Remove the blow hole cap from the body of the cleaner.

4)Connect the hose clamper to the blow hole.

NOTE: Don’t use your vacuum-cleaner outdoors.

USING THE MITE KILLER (OPTIONAL)

1)Disconnect the body connector from the body of the cleaner.

2)Shut the hose connection cover until tone is heard.

•Your vacuum-cleaner is not malfuctioning if it starts to operate when the hose connection cover is closed. This will happen if the vacuum-cleaner was on when the hose was removed.

3)Mite killer lamp on.

Insect and germ killing work is started.

It will continue for 2 to 5min and the process stops automatically.

HOSE CONNECTION COVER

MITE KILLER LAMP

4

Image 5

Contents Vacuum Cleaner Important Safeguards Identification of Parts Power Control only Sliding Regulator TypeHandle Control Operation only Handle Control Type Slide in the Stop PositionAssembling the VACUUM-CLEANER SO That IT is Ready for USE DUST-FULL IndicatorPower Cord ON/OFF SwitchUsing the Blower Except Handle Control Type Using the Mite Killer OptionalPark Position Using the AccessoriesTransporating and Storing the Vacuum Cleaner Replacing the Dust BAG Maintenance or Replacement of the FiltersFor Cloth Filter BAG INLET-FILTERCyclonic Filter Problem Cause RemedyRUG/FLOOR Selector