Husky 16628 Floor KIT Instructions, For 8X8 Buildings, 16 ea 7.6cm galvanized nails

FLOOR KIT INSTRUCTIONS	Parts Needed:
	A	2	- 48x92-5/8x5/8" Floor Panels
FOR 8X8 BUILDINGS	C	5	- 2x4x89-1/2" Floor Joist
ACTUAL SIZE 96” WIDE x 92-5/8” DEEP	D	2	- 2x4x72" Bond Boards
	F	2	- 2x4x24" Bond Boards
			- 2" and 3" Nails

NOTE: Part letters are Not stamped on floor kits. ASSEMBLY OF 8’ x 92-5/8” FLOOR FRAME

IMPORTANT!

If you will be storing heavy items (such as lawn tractor, motorcycle, snowmobile etc.) we recommend you upgrade from 24” on center (61 cm) to 12” on center (30.5cm) floor framing. This requires you to add the following material:

• Qty. (4) of 2”x 4”x 89-1/2” (5 x 10 x 227 cm) Treated • 16 ea. 3” (7.6cm) galvanized nails

DF

A

CCC

92-5/8"

F		D
24"	24"	24"	24"
(61 cm)	(61 cm) Center of	(61 cm)	Center of (61 cm)
	Stud		Stud
	96"
	(244 cm)

C

F

DC

D

(4) 3" Nails

at Joint

(2) 3" Nails

A:Position Floor Joists C 89-1/2”, Floor Bond Boards D 72”, and Floor Bond Boards F 24” as shown.

Using 3” nails, nail twice through

each Bond Board	D & F into each
end of each Joist	C , keeping pieces

flush at top and ends, and maintain 24” spacing. Where D & F join together use 4-3” nails.

B

Y

X

B:Completed Floor Frame should be positioned at building site, leveled,

using shims between floor frame and ground before proceeding to Floor Panel Attachment.

Square frame by making corner-to- corner measurements (X to X and Y to Y) the same.

X

Y

2