Husky 16628 instruction manual For 10X8 Buildings, 20 ea 7.6cm galvanized nails

FLOOR KIT INSTRUCTIONS	Parts Needed:
	A	2	- 48x92-5/8x5/8" Floor Panels
	B	1	- 23-7/8x92-5/8x5/8" Floor Panel
FOR 10X8 BUILDINGS	C	6	- 2x4x89-1/2" Floor Joist
ACTUAL SIZE 120” WIDE x 92-5/8” DEEP	D	2	- 2x4x72" Bond Boards
	E	2	- 2x4x48" Bond Boards

- 2" and 3" Nails

NOTE: Part letters are Not stamped on floor kits. ASSEMBLY OF 10’ x 92-5/8” FLOOR FRAME

IMPORTANT!

If you will be storing heavy items (such as lawn tractor, motorcycle, snowmobile etc.) we recommend you upgrade from 24” on center (61 cm) to 12” on center (30.5cm) floor framing.This requires you to add the following material:

• Qty. (5) of 2”x 4”x 89-1/2” (5 x 10 x 227 cm) Treated • 20 ea. 3” (7.6cm) galvanized nails

A				D		E
		C			C	C
							92-5/8"
E						D
24"		24"			24"	24"	24"
(61 cm)	(61 cm)			(61 cm)		(61 cm)	(61 cm)
Center of			Center of		Center of	Center of
	Stud		Stud		Stud	Stud
					120"
					(305 cm)
				C
	E					D	C
(4) 3" Nails			D
at Joint
						(2) 3" Nails

NOTE: Part letters are not stamped on floor kits.

ASSEMBLY OF 10’ x 92-5/8” FLOOR FRAME

A:Position Floor Joists C 89-1/2”, Floor Bond Boards D 72”, and Floor Bond Boards E 48” as shown.

Using 3” nails, nail twice through

each Bond Board D & E into each end of each Joist C , keeping pieces flush at top and ends, and maintain 24” spacing. Where D & E join together use 4-3” nails.

B

Y X

B: Completed Floor Frame should be positioned at building site, leveled,

using shims between floor frame and ground before proceeding to Floor Panel Attachment.

Square frame by making corner-to- corner measurements (X to X and Y to Y) the same.

XY

5