19 | 20 |
| 21 | c |
|
| c |
|
|
|
| b | a | d |
|
|
| ||
|
|
|
| |
|
| a |
| b |
|
|
|
| |
22 | 23 |
|
|
|
|
| Slots |
|
|
| a |
|
|
|
Parts Checklist |
| Features |
|
|
Read all instructions thoroughly before assembly/use. Please unpack carton, removing all parts and packages. Check that all parts required for assembly are present by referencing the list below.
PARTS | QUANTITY | |
1. | Oreck Steemer Unit | 1 |
2. | Handle | 1 |
3. | Oreck Steemer Power Nozzle | 1 |
4. | Large, | 2 |
5. | Easy | 1 |
6. | Screws (5/8”) | 4 |
7. | 1 | |
8. | Squeegee (for hard floor cleaning) | 1 |
9.25’ Power Cord
10.A.L.C.I. – Safety Plug with Reset and Test Buttons
11.Translucent Upper Supply Tank
12.Translucent Lower Recovery Tank
13.Transparent Nozzle Cover
14.Motorized Scrubbing Brush
15.Convenient
16.Floor Stand
17.Nozzle Power Cord
18.Support Legs
OPERATOR CONTROLS
19. Rinse/Shampoo Switch |
20. Shampoo/Cleaner Spray Button |
20
| 23 |
| 2 |
| 1 |
| 15 |
| 19 |
| 6 |
HOW TO USE | 9 |
THE A.L.C.I |
|
10
21
5
17 
18
4
725
11
12
22
24
3
13
168
14
21. | A.L.C.I. Plug Reset Button |
22. | Tank Latch |
23. | On/Off Power Switch |
24. | Nozzle Change Button |
25. |
To Assemble Cleaner
A PHILLIPS SCREWDRIVER IS REQUIRED FOR ASSEMBLY! fig. 1
a.Lay the cleaner on a flat surface with the tank side down or to its side.
b.Slide handle into cleaner body until interlock is secured.
c.Insert four 5⁄8” screws (included) into the four cavities in the handle base and tighten.
fig. 2
a.Locate two wheels and two support legs.
b.Insert the wheels (a) into the support legs (b) by pushing the wheels in until they snap into place.
fig. 3 Attach Nozzle:
Turn the unit so that the tank is face up.
a. Align the nozzle so the nozzle change button is in line with the |
corresponding hole in the nozzle. Depress the small nozzle |
change button and slide the nozzle over the unit shaft until the |
button locks into place. |
NOTE: Before using, please read the important safety and operating instructions.
4