Oreck 79052-01REVA manual Replacing Edge Brush, Replacing the LED Light, Stuffing or Blockage

Page 7

E N G L I S H

SPECIALNORMAL

20

21

22

23

24

25

Replacing Edge Brush

WARNING: Unplug cord from electrical outlet before servicing.

26Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush.

Remove both edge brushes and replace with new ones. Replace both screws and tighten.

Replacing the LED Light

The light assembly should be replaced by an Oreck authorized service center whenever it fails to light during operation.

Stuffing or Blockage

26

IMPORTANT: On plush and new carpets, stuffing may occur inside the intake tube and the lower tube assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow these steps:

WARNING: Unplug cord from electrical outlet before servicing.

27Check for blockage at the mouth of the intake opening. If there is blockage, remove it with long-nose pliers,

a screwdriver or coat hanger. If you can not reach the blockage, remove baseplate. Remove the base plate by removing 5 screws (see “Adjusting or Replacing Brushroll”).

28If the blockage is not at the base, remove lower tube. Unhook bag spring, releasing bottom of bag. Open elcroed Outer bag lower cover to gain access to Collars and Lower Tube.

29Twist lower collar counterclockwise to slide up. Pull tube out of base. Check for blockage. If blockage is in the tube, remove with a coat hanger.

30If tube is not blocked, look into fan housing. Remove debris with long-nose pliers, a screwdriver or coat hanger.

31To reassemble, check O-ring on tube, and replace if damaged. Replace tube by first lining up slot at base of tube with tab inside fan housing.

32Insert tube and push down until the tube is seated. Make sure O-ring is in place against fan housing opening. Replace and tighten collar until collar locking tabs are locked in place. Reattach bag spring. Close Outer bag lower cover with Velcro®.

33Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that

happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. Note: If the above actions do not correct the problem, contact an Oreck authorized service center or call the

customer service center. US: 1-800-989-3535 Canada: 1-888-676-7325

27

28

29

30

31

32

33

Velcro® is a registered trademark owned by Velcro Industries B.V. Limited Liability Company Netherlands.

Page 6 Page 8
Image 7
Page 6 Page 8
Contents User’s Guide Powerful, Lightweight Upright VacuumGeneral Warnings Safety Enjoy Call Click VisitHousehold Use Only Operation ContentsOperating Instructions Assembling the Handle TubeOperating the U7200 StorageGeneral Information Replacing Disposable Odor Fighting Dust Bag Adjusting or Replacing BrushrollReplacing Worn Belt Replacing the LED Light Replacing Edge BrushStuffing or Blockage Parts Problem Check What to doPart Number Total Cleaning System WarrantyGuide d’utilisation Aspirateur-balai puissant et légerMises en garde générales Sécurité Appréciez Appelez Cliquez VisitezUtilisation domestique uniquement Complet ContenuFonctionnement Liste de piècesInstructions d’utilisation Montage du tube de mancheUtilisation de l’ U7200 EntreposageInformations générales Remplacement de courroie usée Remplacement du sac à poussière jetable anti-odeursRéglage ou remplacement du rouleau-brosse Remplacement de l’éclairage à DEL Remplacement des brosses à borduresBourrage ou blocage Description Contacts d’urgence du service à la clientèlePièces Problème Vérification Action à prendreSystème complet de Nettoyage GarantieGuía del usuario Aspiradora vertical, liviana y poderosaSólo uso doméstico Seguridad DisfrútelaLlame Haga clic Visite Advertencias generalesSistema de Limpieza Total ContenidoOperación Lista de piezasInstrucciones de operación Ensamblaje del tubo-mangoManejo de la aspiradora U7200 AlmacenamientoLa correa Información generalSistema de filtro hipo-alergénico HEPA-Celoc Sistema 360º Glide Deslizamiento de 360ºAjuste o reemplazo del rodillo-cepillo MantenimientoReemplazo de la bombilla LED Reemplazo del cepillo de bordeAtestadura de material u obstrucción Ítem Problema Revisar Qué se debe hacerPiezas AccesoriosGarantía REV a 11/09 ECN# R-9554

79052-01REVA specifications

The Oreck 79052-01REVA is a highly regarded vacuum cleaner that has earned a reputation for its exceptional performance and user-friendly design. Crafted with a focus on both efficiency and convenience, it is ideal for homeowners seeking a reliable cleaning solution.

One of the key features of the Oreck 79052-01REVA is its lightweight design. Weighing in at just 8 pounds, this vacuum is easy to maneuver, making it perfect for users of all ages. Whether you’re carrying it upstairs or navigating tight spaces, the lightweight body eliminates the strain often associated with vacuuming.

This model also boasts a powerful multi-stage filtration system. Equipped with a HEPA filter, it captures 99.97% of dust, allergens, and other particles as small as 0.3 microns. This feature is especially beneficial for allergy sufferers, as it helps to improve indoor air quality. Additionally, the vacuum's filter is easy to access and replace, ensuring that maintenance is a breeze.

The Oreck 79052-01REVA utilizes a unique Saniseal technology, which ensures that dirt and debris are sealed inside the vacuum bag when removed. This design minimizes the risk of dust escaping back into the air, contributing to a cleaner and healthier living environment. The vacuum bags themselves are extra large, capable of holding more dirt, which means fewer trips to the trash and less frequent bag changes.

Another standout characteristic of this vacuum cleaner is its durability. Oreck is known for crafting robust products, and the 79052-01REVA is no exception. With a strong motor and solid construction, this vacuum is built to handle heavy-duty cleaning tasks over the long term.

The ergonomic design of the handle adds to the overall comfort of using the vacuum. The handle is comfortable to grip, reducing fatigue during extended cleaning sessions. The vacuum also includes a variety of cleaning attachments, such as a dusting brush and crevice tool, allowing users to tackle different surfaces and hard-to-reach areas with ease.

With its combination of lightweight construction, advanced filtration system, and user-friendly features, the Oreck 79052-01REVA stands out as a smart choice for those looking to maintain a clean home effortlessly. Whether it’s carpets, hardwood floors, or upholstery, this vacuum provides versatility and efficacy, making it a valuable addition to any cleaning arsenal.
Top Page Image Contents