Heath Zenith 4193 warranty Testing, Specifications

Sensor has a 1 1/2 minute warm up pe- riod before it will detect motion.When first turned on, wait 1 1/2 minutes.

TESTING

❒Turn on the circuit breaker and light switch.

Note:

❒Switch the on-time to TEST position and DualBrite® switch to the OFF position.

TEST 1 5 10 MIN		OFF 3 6 DUSK TO
	ON-TIME		HOUR DAWN

Avoid aiming the control at:

•Objects that change temperature rapidly, such as heating vents and air condition- ers. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor.

180°

6 ft.

(1.8 m)

30ft.

(9.1 m)

Maximum Range	Maximum
	Coverage Angle

The detector is less sensitive to motion directly towards it and more sensitive to across motion.

MotionMotion

	Sensor
Least Sensitive	Most Sensitive

❒Walk through the coverage area noting where you are when the lights turn on.

❒If you need to change the sensitivity, temporarily remove the fixture and make the adjustment. Too much sensitivity may increase false triggering.

❒Set the amount of TIME you want the light to stay on after motion is detected. (1, 5, or 10 minutes).

❒Set the amount of time after dusk you want the lights on accent level.

SPECIFICATIONS

Range . . . . . . Up to 30 ft. (9.1 m) [varies with surrounding temperature].

Sensing Angle. . . Up to 180°

Electrical Load. . . See rating on fixture for maximum wattage.

Sensor Capacity . . Up to 360 Watt (3.0 A.) Maximum

Power

Requirements . . . 120 VAC, 60 Hz Operating Modes. . TEST, AUTO, and

MANUAL MODE Time Delay . . . . 1, 5, 10 minutes DualBrite® timer . . 3, 6 hrs, Dusk-to-Dawn

DESA Specialty Products reserves the right to discontinue products and to change specifica- tions at any time without incurring any obliga- tion to incorporate new features in products previously sold.

598-1167-03