DeLonghi WE 110, WE 130, WE 115 manual Self-Diagnosis, Frost prevention

Page 15

SELF-DIAGNOSIS

The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display.

IF ...	IS DISPLAYED,		...WHAT SHOULD I DO?

			The appliance is fitted with a frost protection device to avoid excessive formation

			of ice. The appliance starts up again automatically when the defrosting process is
			completed.

Low Temperature
(frost prevention)
			Empty the internal safety tank following the instructions in the section “End of season

			operations”. If it reoccurs, contact your local authorized service center.

High Level

(internal tray full)

When this message is displayed, the water filter needs replacing as described in the section: “Replacing the limescale filter”.

Change filter

IF ... IS DISPLAYED,			...WHAT SHOULD I DO?

			If this is displayed, contact your local authorized service center.


	Probe Failure
(sensor damaged)
			When the F1 alarm is active, the appliance continues functioning normally in air-air

			mode.
			To reset the alarm, unplug the appliance then plug in again.
			If the alarm reoccurs frequently, contact customer services.

	Failure1

15

Image 15

Contents 115V~60Hz 1500W Climatizador PortátilP O R T a N T S a F E G U a R D S During the summer, you feel comfortable at a What is the WATER-AIR PinguinoDescription Air-conditioning without installation Preparing for USEProvided to hold the two parts of the win- dow together fig Window pane Wooden kickboard of a French window Air-conditioning with installationWhen the water in the tank runs out, Preparing for Operation in WA- TER ModeSetting water hardness Once the appliance has been installed, it is ready for useReplacing the limescale filter Turn the appliance off and unplug it from the outletLay the appliance on its back as shown in figure Turning the appliance on Operating from the Control PanelAir conditioning mode fig Dehumidifying mode figFan mode fig Choose the required fan speed Smart mode figTo set this mode Description of the Remote CON- TrolTime is reached Using the Remote ControlSetting the time Inserting or replacing the batteriesSelecting the temperature scale fig Boost function figSleep function fig Programming the Timer Programming start upProgramming shutdown Frost prevention SELF-DIAGNOSISTips for Correct USE AIR Purifying FiltersClose doors and windows Cleaning Emptying the internal tank Start of Season OperationsEND of Season Operations Emptying the tankTechnical Characteristics GuaranteeLimit conditions Troubleshooting Please contact our toll free hotline at If repairs become necessary, see contact information below