Bionaire BRH840 manual Please Read and Save These Important Safety Instructions

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

AUTO SAFETY SHUT-OFF WITH MANUAL RESET

This heater is equipped with a patented, technologically advanced safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume oper- ation when the user resets the heater.

TO RESET THE HEATER:

1.Unplug the heater and wait 10 minutes for the unit to cool down.

2.After the 10 minutes, push the RESET button.

3.Plug the unit in again and operate normally.

TIP-OVER PROTECTION:

When the heater is accidentally knocked over, it will automati- cally shut off. To reset, simply place the heater in an upright position. Press the mode button and operate normally.

ASSEMBLY INSTRUCTIONS

1.Carefully remove your heater from the box. (Please save the carton for off-season storage.)

2.Insert the right portion of the metal base tubing into the left portion of the metal base tubing, and push togeth- er until the 3 screw holes line up. (See Figure 1).

3.Make sure the power cord comes straight out of the hole in the middle of the base without obstructing the channels on the bottom of the base.

4.Place the assembled metal base tubing in the channels on the bottom of the base. (See Figure 2).

5.Secure metal tubing to the base with the three screws provided.

6.Turn heater upright and follow operating instructions below.

Figure 1 Figure 2

PRE-OPERATING INSTRUCTIONS

1.Make sure the unit is in the OFF position before plug- ging the heater into the outlet.

2.Place heater on firm level surface.

3.Avoid overloading your circuit by not using other high wattage appliances in the same outlet.

NOTE: This unit is for FLOOR USE ONLY.

OPERATING INSTRUCTIONS
1.	Set the heat selector switch to the
		Figure 3
	OFF position.
2.	Plug in heater.
3.	For heater operation, turn heat
	selector knob on the back of the
	unit to LOW or HIGH, depending on
	your heat setting preference.

NOTE: The POWER light will remain lit during operation.

NOTE: Check to be sure that there are no objects between you and the heater. Such objects will absorb the heat and prevent it from reaching you.

NOTE: The parabolic design of the reflector focuses heat at people and objects located 3 to 10 feet in front of the heater. Therefore, to fully enjoy the sun-like warmth pro- duced by the heater, it must be positioned at least three feet from you. Placing it closer is not recommended. Try different positions until you find the optimal one for you.

CLEANING/MAINTENANCE

DURING SEASON CARE:

1.Always unplug the heater before cleaning.

2.Clean the unit with a soft cloth moistened with a mild soap solution.

3.NEVER use abrasive or flammable solvents to clean the unit.

4.To clean parabolic reflector dish we recommend the use of a thin brush. This brush can be inserted through the front grill in order to move any dust or debris to the lower edge of the reflector dish. DO NOT REMOVE THE GRILL. Use a vacuum to remove dust or debris from the outer edge of the reflector dish.

5.After cleaning, be sure to completely dry the unit with a cloth or towel.

3 4