Assembly Instructions

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

The Air Cleaner requires very little assembly; therefore, determine in which position the Air Cleaner will be used - on the floor, bench or overhead. If the Air Cleaner will be used as a mobile unit, proceed to “USING THE AIR CLEANER ON A BENCH OR FLOOR SURFACE” section. If ceiling mounting, proceed to section “MOUNTING THE AIR

CLEANER TO A CEILING OR OVERHEAD SUPPORT.”

IMPORTANT: When determining a location to mount the air cleaner, the unit will operate more efficiently when the air flow is unrestricted. Do not locate the unit in a corner or near any heating or cooling vents.

USING THE AIR CLEANER ON A BENCH OR

FLOOR SURFACE

1.Locate (4) self-adhesive rubber feet (D) Fig. 2, supplied with the unit. Carefully place Air Cleaner on a firm supporting surface so there is access to the bottom of the cabinet as shown in Fig. 3. Apply one self- adhesive rubber pad, to bottom at each corner (A) Fig. 3, of air cleaner cabinet. The rubber feet will help eliminate vibration and the possibility of the air cleaner “walking” across the work or floor surface.

For operator safety, we suggest that the unit be clamped down when used on a work bench or positioned on sawhorses.

Fig. 3

2.There are two lifting handles located on each side of the cabinet as shown in Fig. 4, to assist in carrying the unit from one place to another. To avoid damage to the air filters, carry the air cleaner with the filters positioned away from your body. CAUTION: THIS MACHINE

WEIGHS APPROXIMATELY 50 POUNDS.

Fig. 4