Dyna-Glo RMC-KFA120TDLX, RMC-KFA170TDLX user manual Pump Pressure Adjustment

NEVER LEAVE THE HEATER	NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!	UNATTENDED WHILE BURNING!
H.) FUEL FILTER	10. TROUBLE SHOOTING GUIDE

CLEAN OR REPLACE TWICE A HEATING SEASON OR AS NEED.

-Remove upper shell(See 10 page).

-Remove Fan Blade(See 11 Page).

-Pull Fuel Line off from Fuel Filter Neck.

-Remove Fuel Filter.

-Wash Fuel Filter with clean kerosene and replace in tank.

-Attach Fuel Line to Fuel Filter Neck.

-Replace Fan Blade and Upper Shell.

I.) PUMP PRESSURE ADJUSTMENT

-Start Heater(See Operation, Page 8) and allow motor to reach full speed.

-Adjust Pump Pressure.(Using a Flat blade screwdriver)

Turn Relief Valve clockwise to increase pressure. Turn Relief Valve counter-clockwise to decrease pressure.

Set Pump pressure according to the chart below. -Stop Heater(See Operation, Page 8).

MODEL	PUMP PRESSURE
RMC-KFA65TDLX	3.5 psi
RMC-KFA120TDLX	4.5 psi
RMC-KFA170TDLX	6.5 psi

Figure 18. Removing Fuel Filter

Figure 19. Adjusting Pump Pressure

NOTE: USE ONLY ORIGINAL EQUIPMENT REPLACEMENT PARTS.

USE OF ALTERNATE OR THIRD PARTY COMPONENTS WILL VOID ANY WARRANTY AND MAY CAUSE UNSAFE OPERATING CONDITION.

13 14