Operation, Assembly, Ventilation, To Start Heater

Dayton Operating Instructions and Parts Manual

Models 2E510D, 2E511D, 3E218D, and 3E219C

General Safety Information

(Continued)

ASSEMBLY

(For Models 3E218D and 3E219C Only)

These models are furnished with wheels and handles. Wheels, handles, and the mounting hardware are found in the shipping carton.

TOOLS NEEDED

•Medium Phillips Screwdriver

•3/8" Open or Adjustable Wrench

•Hammer

1.Slide axle through wheel support frame. Install wheels on axle.

Front Handle

Rear Handle

IMPORTANT: When installing wheels, point extended hub of wheels toward wheel support frame (see Figure 6).

2.Place cap nuts on axle ends. Gently tap with hammer to secure.

3.Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Line up holes on fuel tank ﬂange with holes on wheel support frame.

4.Place front handle and rear handle on top of fuel tank ﬂange. Insert screws through handles, fuel tank ﬂange, and wheel support frame. Attach nut ﬁnger tight after inserting each screw.

5.After inserting all screws, tighten nuts ﬁrmly.

VENTILATION

Operation

Review and understand the

warnings in the Safety Information Section. They are needed to safely operate this heater. Follow all local codes when using this heater.

TO START HEATER

1.Follow all ventilation and safety information.

2.Fill fuel tank with kerosene or No. 1 fuel oil.

3.Attach fuel cap.

4.Plug power cord of heater into three-prong, grounded extension cord. Extension cord must be at least six feet long.

EXTENSION CORD WIRE SIZE

REQUIREMENTS

•6 to 10 feet long, use 18 AWG rated cord.

		Screw
	Hot Air
	Outlet
	Fuel	Air
	Tank	Air
	Tank	Inlet
	Flange	Inlet
	Flange

Wheel Support

Frame

Nut

Extended

Hub

Axle

Cap Nut

Wheel

Figure 6 - Wheel and Handle Assembly, Models 3E218D and 3E219C Only

Follow the mini- mum fresh, outside

air ventilation requirements. If proper fresh, outside air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, outside air ventilation before running heater.

Provide a fresh air opening of at least three square feet for each 100,000 Btu/Hr rating. Provide extra fresh air if more heaters are being used.

Example: A 150,000 Btu/Hr heater requires one of the following:

•a two-car garage door raised six inches

•a single-car garage door raised nine inches

•two, thirty-inch windows raised twelve inches

•11 to 100 feet long, use 16 AWG rated cord.

•101 to 200 feet long, use 14 AWG rated cord.

Flame-out Control

Reset Button

Figure 7 - Flame-out Control Reset Button, Models 2E510D and 2E511D

101421