ASSEMBLY INSTRUCTIONS
Continued
CHECK FOR LEAKS
IMPORTANT: The heater must be leak tested be- fore any further assembly is done. Use only a soap and water solution. DO NOT USE FLAME.
Turn control knob to the "OFF" position. Securely connect regulator to propane/LP gas cylinder. Open propane/LP cylinder valve. Apply a soap and water solution to connections at the manifold, burner, and control assembly. Bubbles forming show a leak. In case of any leaks, turn off pro- pane/LP cylinder valve, remove manifold, check and clean connection. Reconnect manifold and leak test again.
Upon completion of leak test, and when there is no sign of a leak, turn off propane/LP cylinder valve and disconnect regulator from propane/LP gas cylinder. Remove propane/LP gas cylinder and continue to next step.
POLE AND BURNER/CONTROL ASSEMBLY
Attach pole to burner and control assembly (see Figure 6). Align the three holes. Insert a small bolt in each hole and tighten using #2 Philips head screwdriver.
MANIFOLD FIXING PLATE AND POLE SUPPORT
1.Locate threaded hole underneath post support. This hole is for mounting manifold fixing plate (see Figure 7).
2.Align holes on manifold fixing plate with threaded holes on pole support.
3.Make sure manifold fixing plate is facing downward see (Figure 7).
4.Use a medium bolt to tighten manifold fixing plate to post support using #2 Philips head screwdriver.
5.Turn manifold fixing plate so it will hold manifold in place.
6.Tighten medium bolt so manifold fixing plate will not move.
Manifold
Fixing Plate
Figure 7 - Attaching Manifold Fixing
Plate to Post Support
Figure 6 - Attach Burner and Control
Assembly to Pole
6 | www.desatech.com |