Rear 2 Ft | Desa ROPANE CONSTRUCTION HEATERS specs

SAFETY INFORMATION

Continued

!WARNINGS

Propane Gas: Propane gas is odorless. An odor-making agent is added to propane gas. The odor helps you detect a propane gas leak. However, the odor added to propane gas can fade. Propane gas may be present even though no odor exists.

Make certain you read and understand all Warnings. Keep this manual for reference. It is your guide to safe and proper operation of this heater.

•For indoor use only. Provide adequate ventilation.

•Use only in well vented areas. Before using heater, provide at least a three- square-foot opening of fresh, outside air for each 100,000 BTU/Hr of rating. This heater produces carbon monoxide, which is listed by the State of Califor- nia as a reproductive toxin under Proposition 65.

•Do not use heater outdoors or in occupied dwellings.

•Do not use heater in living or sleeping quarters.

•Keep appliance area clear and free from combustible materials, gasoline, paint thinner, and other flammable vapors and liquids. Do not use heater in areas with high dust content.

•Keep heater away from strong drafts, water spray, rain, or dripping water.

•Install and use heater with care. Follow all local ordinances and codes. In the absence of local ordinances and codes, refer to ANSI/NFPA 58. This instructs on the safe storage and handling of propane gases.

•Check heater for damage before each use. Do not use a damaged heater.

•Use only propane gas set up for vapor withdrawal.

•Keep propane tank(s) below 100° F.

•Do not use heater below ground level. Propane gas is heavier than air. If a leak occurs, propane gas will sink to the lowest possible level.

•Use only the electrical voltage and frequency speciﬁed on model plate.

•The electrical connections and grounding of the heater shall follow the Na- tional Electric Code, ANSI/NFPA 70.

•Electrical grounding instructions — This appliance is equipped with a three- prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.

•Use only a three-prong, grounded extension cord.

•Use only the hose and factory preset regulator provided with the heater.

•Inspect hose before each use of heater. If highly worn or cut, replace before using heater. Use the replacement hose assembly speciﬁed in this manual.

•Keep heater at least six feet from propane tank(s). Do not point heater at propane tank(s) within 20 feet.

•Minimum heater clearances from combustibles:

Outlet: 8 Ft.

Sides: 2 Ft.

Top: 6 Ft.

Rear: 2 Ft.

•Locate heater on stable and level surface if heater is hot or running.

•Keep children and animals away from heater.

•Turn off propane supply and unplug heater when not in use.

•When used with thermostat, heater may start anytime.

•Never block air inlet (rear) or air outlet (front) of heater.

•Never move, handle, or service a hot, operating, or plugged-in heater.

•Do not alter heater. Keep heater in its original state.

•Do not use heater if altered.

•Never attach duct work to front or rear of heater.

•Use only original replacement parts. This heater must use design-specific parts. Do not substitute or use generic parts. Improper replacement parts could cause serious or fatal injuries.

099162

ROPANE CONSTRUCTION HEATERS specifications

Desa Ropane Construction Heaters are renowned for their efficiency and reliability in providing heat in various construction environments. These powerful heaters are specifically designed to meet the demands of the construction industry, where maintaining a suitable temperature is crucial for worker safety and the integrity of materials.

One of the main features of Desa Ropane heaters is their robust construction. Built to withstand the rigors of job sites, these heaters are made from durable materials that can resist wear and tear. This durability ensures that the heaters can operate in harsh conditions without compromising on performance.

Desa Ropane heaters utilize advanced infrared technology to produce heat. This technology allows for efficient heating, as infrared rays directly warm people and objects, rather than the air. This makes them especially effective in large, open spaces where conventional heating methods might struggle to maintain warmth. By focusing on direct heat transfer, these heaters minimize energy waste and reduce heating costs.

Another characteristic of Desa Ropane heaters is their user-friendly design. Many models come equipped with easy-to-use controls that allow operators to adjust the temperature settings quickly. This feature is particularly beneficial for construction workers who may need to respond rapidly to changing weather conditions. Additionally, several models feature built-in safety mechanisms, such as tip-over switches and overheat protection, ensuring safe operation even in the most challenging environments.

Portability is yet another strength of Desa Ropane heaters. Many models are lightweight and fitted with wheels, making it easy to move them around job sites as needed. This flexibility is invaluable in dynamic construction environments where heating requirements may change throughout the day.

Moreover, Desa Ropane heaters operate quietly, which is an essential feature for construction sites that may need to comply with noise regulations or where workers require a more peaceful working atmosphere.

In summary, Desa Ropane Construction Heaters are crafted with durability, efficiency, and user convenience in mind. With their infrared heating technology, built-in safety features, exceptional portability, and quiet operation, they are ideal solutions for meeting the heating needs in construction settings. Their reliable performance makes them a go-to choice for contractors and construction companies looking to ensure a warm and safe working environment during cold months.