OWNERS MANUAL
SAFETY
INFORMATION
Continued
13.Do not operate heater if any log is bro- ken. Do not operate heater if a log is chipped
14.Turn heater off and let cool before ser- vicing. Only a qualified service person should service and repair heater.
15.Operating heater above elevations of 4,500 feet may cause pilot outage.
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.
1. | Remove logs and heater base assem- |
| bly from carton. Note: Do not pick up |
| heater base assembly by burners. This |
| could damage heater. Always handle |
| base assembly by grate. |
2. | Remove all protective packaging ap- |
| plied to logs and heater for shipment. |
3. | Check all items for any shipping dam- |
| age. If damaged, promptly inform |
PRODUCT
IDENTIFICATION
Top Middle Log |
|
Crossover Log | Rear Log |
| |
Left Front Log |
|
| Rear | |
| Burner | |
Piezo |
| |
Ignitor |
| |
Front |
| |
Burner |
| |
Base Assembly | Bottom | |
Middle Log | ||
| ||
Control Knob | Right Front Log | |
Figure 1 - Ember Master |
|
dealer where you bought heater. |
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing coals. This heater is designed for
SAFETY DEVICE
This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
105070 | 3 |