Desa VF-18N-PDG, VF-24P-PDG, VF-24N-PDG Thermostat Control Operation, Ghrcta Series Operation

16

OPERATING HEATER (REMOTE-READY MODELS)

Lighting Instructions (Cont.)

To Turn Gas Off To Appliance

Manual Lighting Procedure

Optional Remote Operation

OPERATING HEATER

Continued

IMPORTANT: Do not leave the selector switch in the RE- MOTE or ON position when the pilot is not lit. This will drain the battery.

3.To turn the burner off, press the AUTO/ON/OFF button until OFF lights. The pilot will remain lit.

IMPORTANT: To turn the pilot off, manually turn the control knob on the heater to the OFF position.

2.Press the ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.

IMPORTANT: Be sure to press the ON/OFF buttons on the hand-held remote control unit for up to 3 seconds to assure proper operation.

Note: All additional remote control accessories must be pur- chased separately (see Accessories, page 27). Follow instructions included with the remote control.

Thermostat Control Operation

(Optional GHRCTA Series Only) The thermostat control set- ting on the remote control unit can be set to any comfort level between WARMER and COOLER. The burners will turn on and off automatically to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central

	Selector Switch in
Control Knob	OFF Position
F			REMOTE
O
IL	T
P	O
F	N
O	OL		OFF
		AUTO
			ON
		OFF
		ON
	HI
Ignitor Button	Flame Adjustment Knob

Selector Toggle Switch

(Optional Remote Control)

Figure 20 - Setting the Selector switch, Control Knob, and Flame Adjustment Knob for Remote Operation

heating system, etc.

For wall thermostat operation, follow instruction supplied with thermostat accessory GWMT1. For wall switch operation follow instructions supplied with GWMS2.

NOTICE: You must light the pilot before using the remote control unit. See Lighting Instructions on page 14.

GHRCTA Series Operation:

2a. Press the AUTO/ON/OFF button on the hand-held remote control (see Figure 33). The lights to the left of the button will show AUTO, ON, or OFF.

Shows

Temperature

Setting

The Log Heater will Automatically Cycle between

Pilot and the Heat Setting that has

been Selected

Increases Room

Temperature in

AUTO Mode

Decreases Room

Temperature in

AUTO Mode

Turns Burners On or Off and Allows You to Choose the Auto Setting

•In the ON mode, the burners will ignite. The heater is in manual mode when ON is lit.

•In the AUTO mode, the thermostat in the hand-held remote unit controls the room temperature. To increase the room temperature, press the top arrow of the TEMP button. To lower the room temperature, press the bottom arrow of the TEMP button. At higher settings the heater will run longer.

IMPORTANT: This remote control has been specially engineered to take an air temperature sample every 5.5 minutes in the auto mode. It will not respond immediately to the temperature setting being turned up or down.

IMPORTANT: The hand-held remote control unit must be near the heater. Do not keep the hand-held remote control unit too close to the heater. The thermostat on the hand- held remote control unit will heat up too quickly and turn the heater off.

Figure 21 - Thermostat Hand-Held Remote Control Unit Selections (GHRCTA Only)

For more information, visit www.desatech.com

111826-01