Desa FVFM27PR Installing Damper Clamp Accessory for Vented Operation, Masonry Fireplace

Page 11

INSTALLATION

Continued

B.If combustible materials are less than 14" to the fireplace, you must install appliance at least 5" above the combustible flooring (see Figure 9).

Hearth

Combustible Material

5"

Min.

Figure 9 - Minimum Fireplace Clearances

Above Combustible Flooring

INSTALLING DAMPER CLAMP ACCESSORY FOR VENTED OPERATION

Note: When used as a vented heater, appliance must be installed only in a solid-fuel burning fireplace with a working flue and constructed of noncombustible material.

If your heater is a manually controlled model, you may use this heater as a vented product. There are three rea- sons for operating your heater in the vented mode:

1.The fireplace does not meet the clearance to com- bustibles requirements for vent-free operation

2.State or local codes do not permit vent-free operation

3.You prefer vented operation

If reasons number 1 or 2 above apply to you, you must permanently open chimney flue damper. You must install the damper clamp accessory (to order, see Accessories, page 25). This will insure vented operation (see Figure 10). The damper clamp will keep damper open. Installation instructions are included with clamp accessory.

See chart below for minimum permanent flue opening you must provide. Attach damper clamp so the minimum permanent flue opening will be maintained at all times.

Chimney Height

 

Minimum Permanent

 

 

Flue Opening

 

 

 

6' to 15'

 

39 sq. inches

15' to 30'

 

29 sq. inches

 

 

 

 

 

 

Area of Various Standard Round Flues

Diameter

Area

5"

 

20 sq. inches

6"

 

29 sq. inches

7"

 

39 sq. inches

8"

 

51 sq. inches

Damper

Clamp

Damper

Damper

Damper Clamp

 

Masonry Fireplace

Manufactured

 

Fireplace

Figure 10 - Attaching Damper Clamp

INSTALLING HEATER BASE ASSEMBLY

CAUTION: Do not remove the dataplates attached to the heater base assembly. The data plates contain important warranty and safety information.

WARNING: You must secure this heater to fireplace floor. If not, heater will move when you adjust controls. Moving heater may cause a gas leak.

WARNING: If installing in a sunken fireplace, special care is needed. You must raise the fireplace floor to allow access to heater control panel. This will insure adequate air flow and guard against sooting and controls being damaged. Raise fireplace floor with noncombus- tible material. Make sure material is secure.

CAUTION: Do not pick up heater base assembly by the burner. This could damage heater. Only handle base as- sembly by grates.

108382-01G

www.desatech.com

11

Image 11
Contents Also Design-Certified As a Vented Decorative Appliance FLAME-MAXVYM27NR, VYM27PR, FVFM27NR and FVFM27PR Table of Contents Safety Information Product Identification Safety InformationUnpacking Product FeaturesRemote Control Accessories Local CodesDetermining FRESH-AIR Flow for Heater Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Vent-Free Operation Only InstallationInstallation and Clearances Check GAS TypeInstallation Floor Clearances If Using MantelMantel Clearances Masonry Fireplace Installing Damper Clamp Accessory for Vented OperationInstalling Heater Base Assembly Installation Items Needed Connecting to GAS SupplyPropane/LP Gas Natural Gas From Gas MeterTest Pressures Equal To or Less Than Psig 3.5 kPa Pressure Testing Gas Supply Piping SystemChecking GAS Connections Test Pressures In Excess Of 1/2 Psig KPaPressure Testing Heater Gas Connections Installing LogsLighting Instructions For Your Safety Read Before LightingOperating Heater Shutting Off Heater  MANUAL Lighting ProcedureOperating Heater To Turn OFF GAS To ApplianceThermostat Series Model HRC200 Optional Hand-HeldRemote Operation On/Off Series Model HRC100Burner Flame Pattern Inspecting BurnersPilot Flame Pattern Burner Primary AIR Holes Cleaning MaintenanceCleaning Burner Injector Holder and Pilot Air Inlet Hole Inspecting BurnersCleaning Maintenance Observed Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte TroubleshootingMent at top Power is lowWALL-MOUNT Thermostat Receiver and Hand Held Thermostat Remote ControlReceiver and Hand Held Remote Control WALL-MOUNT ON/OFF SwitchModels VYM27NR, VYM27PR, FVFM27NR and FVFM27PR Illustrated Parts BreakdownParts List Limited Warranty VENT-FREE GAS LOG Heaters Warranty InformationKeep this Warranty

FVFM27PR specifications

Desa FVFM27PR is an innovative and highly adaptable fitness machine that has been designed to meet the diverse needs of users seeking an efficient and effective workout experience. This state-of-the-art equipment combines advanced technologies with practicality, making it a perfect addition to any home gym or fitness facility.

One of the standout features of the FVFM27PR is its versatile design, allowing users to perform a variety of exercises. It includes adjustable settings for resistance, accommodating users of all fitness levels, from beginners to experienced athletes. Its user-friendly interface ensures that anyone can easily navigate through different workout programs and adjust settings to fit their personal goals and preferences.

The FVFM27PR is equipped with cutting-edge fitness tracking technology. This feature helps users monitor their progress by tracking essential metrics such as heart rate, calories burned, and workout duration. With this data readily available, users can optimize their training regimens and make informed decisions about their fitness journeys.

Durability is another hallmark of the FVFM27PR. Constructed from high-quality materials, it promises longevity and stability during intense workout sessions. The machine is designed to withstand rigorous use, ensuring that it remains a reliable part of your fitness routine for years to come.

Additionally, the FVFM27PR offers a compact form factor, making it especially suitable for limited spaces. Its foldable design allows for easy storage when not in use, catering to those who desire a functional workout machine without sacrificing valuable living space.

The ergonomic design of the FVFM27PR enhances the user experience by providing optimal comfort and minimizing the risk of injury. It features adjustable seat and handle positions, allowing users to find their ideal fit for various exercises. This thoughtful design ensures that users can focus on their workouts without discomfort.

Moreover, the FVFM27PR integrates a variety of multimedia features, such as Bluetooth connectivity and compatibility with fitness apps. Users can easily connect their devices to access guided workouts, playlists, or motivation from personal trainers, further enriching the fitness experience.

In summary, the Desa FVFM27PR stands out with its versatility, advanced technology, durability, compact design, ergonomic features, and multimedia capabilities. These characteristics make it an excellent choice for anyone looking to enhance their fitness journey, whether at home or in a gym environment. With the FVFM27PR, achieving fitness goals has never been more accessible and engaging.