OPERATING INSTRUCTIONS
UB-16 Bodypack Transmitter
5. Selecting the Operating Frequency
In order for the system to operate properly, the same channel (frequency of operation) must be selected for the
6.Selecting the Tone Squelch™ Mode/ Activity Indicator
Hold both the UP and DOWN BUTTONS (25) at the same time for 1
second. The Tone Squelch™ will cycle from On to Off. See the CHANNEL DISPLAY AND UP/DOWN BUTTON OPERATION, page 15. (Note: If the receiver is configured for Tone Squelch™ mute, the transmitter must also be configured to send the tones, otherwise the receiver audio will remain muted. The signaling tones are also used to display the transmitter battery status.)
7.Locking the Keyboard
To avoid accidental reconfiguration of the Channel setting or Tone Squelch™ , the keyboard can be locked by holding both UP and DOWN BUTTONS (25) at the same time for 3 seconds. See the CHANNEL DISPLAY AND UP/DOWN BUTTON OPERATION, page 15.
8.Microphone and Instrument Operation
The transmitter is now ready to use. The RECEIVED RF LEVEL ICON (11a), and either the A or B DIVERSITY ICON (11e) on the
(31) |
(32) |
(33) |
a. Instrument Use.
Plug the 1/4" phone plug from the INSTRUMENT (31) cord into the instrument. Verify that the INPUT SELECTOR SWITCH (23) is in the GT position. When ready to play, slide the audio OFF/STANDBY/ON SWITCH (28) to the ON position. Adjust the volume of the receiver as per the Audio Output Instrument Connections section of the preceding
(Note: The INPUT LEVEL CONTROL (26) is deactivated and not used when the
The
(Note: Scratchy noises can sometimes occur when some electric guitars with dirty pots or connections are used with any wireless system. Therefore, the supplied INSTRUMENT (23) cord has a factory installed capacitor inside the 1/4" plug. This capacitor provides first order filtering of the RF signal from the cord into the guitar and eliminates virtually all scratchy noises. Should your equipment still give you scratchy noises, we suggest these steps to eliminate them:
1)Make sure all guitar volume and tone pots are clean and all contacts are
2)Solder a 47pf capacitor across the hot to ground terminals of the guitar’s volume and tone pots to provide extra filtering.)
13