Desa VTDMV18NA, VTDMV24PA Inspecting Burners, Pilot Flame Pattern, ON/OFF Series Model Ghrcb

OPERATING APPLIANCE

Continued

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 10.

After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Flip AUTO/OFF/ON switch to AUTO. Slide the selector switch to the REMOTE position (see Figure 13). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

Control Knob

REMOTE

OFF

ON

INSPECTING BURNERS

Check pilot flame pattern and burner flame pat- terns often.

PILOT FLAME PATTERN

You can view the pilot light through the pilot viewing hole on the pilot bracket. This is located under the front grate bar on the right side of the log set.

Figure 15 shows a correct pilot flame pattern. Figure 16 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the ther- mocouple. This will cause the thermocouple to cool. When the thermocouple cools, the appliance will shut down.

If pilot flame pattern is incorrect, as shown in Figure 16

•turn appliance off (see To Turn Off Gas to Appliance, page 10)

•see Troubleshooting, page 13

Note: The pilot flame on natural gas units will have a slight curve but flames should be blue and have no yellow or orange color.

Thermocouple

		Flame	Selector Switch in
Piezo			REMOTE Position
		Adjustment
Ignitor
		Knob
Figure 13 - Setting the Selector Switch,
Control Knob and Flame Adjustment
	Knob for Remote Operation
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 14).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together on hand-
held remote control until the light stops flashing.
The hand-held remote is now unlocked.
			Control Button
			Turns Burner
			On and Off
Figure 14 - On/Off Hand-Held Remote
		Control Unit (GHRCB)

Figure 15 - Correct Pilot Flame Pattern (Your pilot may vary from pilots shown)

Thermocouple

Figure 16 - Incorrect Pilot Flame Pattern (Your pilot may vary from pilots shown)

BURNER FLAME PATTERN Figure 17 shows correct burner flame pattern.

NOTICE: Do not mistake orange flames with yellow tipping. Dirt or other fine particles are burned by appliance, causing brief patches of orange flame.

Yellow Flames with Orange Streaks

Figure 16 - Correct Burner Flame Pattern

114926-01B www.desatech.com 11