Desa VP10T Lighting Instructions, To Turn OFF GAS To Appliance, Manual Lighting Procedure

Page 10

VANGUARD VP10T

PROPANE/LP GAS HEATER

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information page 9, column 3.

2.Make sure manual shutoff valve is fully open.

3. Turn control knob clockwise Clockwise to the OFF position.

Ignitor Button

Control Knob

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot does not light, repeat steps 3 through 7. This heater has a safety interlock system. Wait one (1) minute before lighting pilot again.

8.Turn control knob counterclockwise

C-clockwiseto desired heating level. Both plaques should light. Set control knob to any heat level between HI and LO.

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1. Turn control knob clockwise Clockwise to the OFF position.

Shutting Off Burner Only (pilot stays lit)

1. Turn control knob clockwise Clockwise to the PILOT position.

 

 

 

Ignitor

Pilot Burner

PILOT

LO

Thermocouple

Electrode

OFF

 

HI

 

 

 

 

IGNITOR

MANUAL LIGHTING

PROCEDURE

1.

Remove front panel (see Figure 10,

 

page 7).

2.

Follow steps 1 through 5 under Light-

 

ing Instructions.

Figure 16 - Control Knob In The OFF Position

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation, column 3, page 9. If you don’t smell gas, go to the next step.

5.Press in control knob, and turn coun-

terclockwise C-clockwiseto pilot posi- tion. Keep control knob pressed for five seconds.

Note: You may be running this heater for the first time after hook- ing up to gas supply. If so, the con- trol knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.

•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the bottom of burner. The pilot can be seen below the left hand plaque. If needed, keep pressing ignitor but- ton until pilot lights.

•If pilot does not stay lit, contact a qualified service person or gas sup- plier for repairs.

Figure 17 - Pilot

CAUTION: Do not try to adjust heating levels by using the

manual shutoff valve.

THERMOSTAT

CONTROL

OPERATION

The control knob can be set to any heat level between HI and LO. When the room tem- perature exceeds the set temperature, the burner will cycle to pilot. The burner will cycle back on when room temperature drops below the set temperature.

Note: The thermostat sensing bulb mea- sures the temperature of air near the heater cabinet. This may not always agree with room temperature (depending on housing construction, installation location, room size, open air temperatures, etc.) Frequent use of your heater will let you determine your own comfort levels.

3.

With control knob pressed in, strike

 

match. Hold match to pilot until pi-

 

lot lights.

4.

Keep control knob pressed in for 10

 

seconds after pilot is lit. After 10 sec-

 

onds, release control knob.

5.

Replace front panel.

10

102489

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Infrared VENT-FREE PROPANE/LP GAS Heater OWNER’S Operation and Installation ManualModel VP10T Safety Information Vanguard VP10T PROPANE/LP GAS HeaterAIR for Combustion and Ventilation Product FeaturesProduct Local CodesConfined and Unconfined Space Unusually Tight ConstructionDetermining AIR Flow for Heater Location Determining if You Have a Confined or Unconfined SpaceVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installing to WallInstalling Bottom Mounting Screw Installing to WallInstalling Two Mounting Screws Placing Heater On Mounting ScrewsConnecting to GAS Supply Sediment TrapFor Your Safety Read Before Lighting Pressure Testing GAS Supply Piping SystemPressure Testing Heater GAS Connections Checking GAS ConnectionsTo Turn OFF GAS To Appliance Manual Lighting ProcedureLighting Instructions Thermostat Control OperationCleaning and Maintenance Inspecting BurnerTroubleshooting Observed Problem Possible Cause RemedyTroubleshooting Gas leak. See Warning statement at Replacement Parts SpecificationsTechnical Service Publications Service HintsIllustrated Parts List VP10T ODS/PILOTParts Available not Shown Vanguard VP10T PROPANE/LP GAS Heater 102489 Warranty Information Limited Warranty Vanguard VENT-FREE Residential GAS Heaters

VP10T specifications

The Desa VP10T is an innovative piece of technology designed to meet the evolving needs of modern living. This versatile device has garnered attention for its blend of functional design, advanced features, and user-friendly operation, making it an attractive option for a wide range of consumers.

One of the standout features of the Desa VP10T is its compact size, allowing it to seamlessly fit into various environments, whether it’s a small apartment, a home office, or a shared workspace. Despite its compactness, the VP10T boasts impressive performance capabilities, ensuring that users do not have to compromise on efficacy in a smaller footprint.

Another key characteristic of the Desa VP10T is its energy efficiency. Equipped with the latest energy-saving technologies, this device helps reduce electricity consumption without sacrificing performance. This is particularly appealing in today’s environmentally conscious world, where consumers are increasingly looking for products that contribute to sustainability.

The Desa VP10T also prioritizes user experience with its intuitive interface. Featuring touch controls and an easy-to-navigate menu, users can effortlessly adjust settings to suit their preferences. Whether it involves customizing the output levels or setting timers for specific functions, the VP10T makes it easy for anyone to operate.

In terms of technological integration, the Desa VP10T supports smart connectivity. This allows users to control the device remotely through a dedicated smartphone app. With this feature, users can monitor performance, receive updates, and even schedule operations, offering convenience that aligns with the demands of contemporary lifestyles.

Safety is another significant aspect of the Desa VP10T. Built-in safety features such as overheat protection and automatic shut-off mechanisms ensure peace of mind for users. These features are essential for families and individuals, providing an added layer of security.

Overall, the Desa VP10T stands out due to its blend of size, efficiency, user-friendliness, and advanced technological integration. With its commitment to sustainability and safety, this device is not just a tool for daily tasks; it is a step towards making life easier and more environmentally responsible. Whether you're looking to enhance your living space or streamline your daily routine, the Desa VP10T offers a solution that is both practical and forward-thinking.
Top Page Image Contents