Samsung VCR8950L3B/SML Max Cleaning, Cancel the mode, Complete, resume cleaning is not performed

Max Cleaning

The vacuum cleaning robot automatically moves and cleans until the battery runs out and the battery level flashes only one level.

■If cleaning begins when the vacuum cleaning robot is docked with the charger station, the time to return to the charger is decreased since the vacuum cleaning robot remembers its original position while moving.

■If the vacuum cleaning robot starts the current cleaning run at a location other than the charging station and fails to locate the charging station while cleaning, it will stop near the location where it started cleaning.

03

OPERATING

■If the battery level becomes low while cleaning, the vacuum cleaning robot automatically returns to the charger station and resumes cleaning after charging the battery. (Number of resumed cleaning operations: Once)

Main unit button	Remote control	Configuration
	button	Sequence
	1.	Set the mode.
▶
3time
2 times in charging mode
	2.	Cancel the mode.	Normal Mode

About the Resume Cleaning function

	•	If the vacuum cleaning robot judges cleaning to be
NOTE		complete, resume cleaning is not performed.

•If you move the vacuum cleaning robot while it is being charged or press a button, vacuum cleaning robot judges cleaning to be complete (cleaning is not resumed).

• Do not move the vacuum cleaning robot while it is cleaning CAUTION or press a button while cleaning. Otherwise, the vacuum

cleaning robot judges cleaning to be complete and starts cleaning again from the beginning.

•Each time you press the Turbo button, the Turbo icon on the display panel is turned on or off sequentially. When the Turbo icon is turned on, you can start cleaning in Turbo mode.

•Each time you press the Dust Sensor button, the Dust Sensor icon on the display panel is turned on or off sequentially. When the Dust Sensor icon is turned on, you can start cleaning in Dust Sensor mode.

Turbo Mode

Dust Sensor Mode

operating _31