Where to Install Your Micro-Compact
System
ENG
To take full advantage of your new
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc compartment easily.
Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed at an equal distance above the floor.
Connecting your System to the
Power Supply
Before plugging your system into a main socket, you must check the voltage.
1 Plug the main lead into an appropriate socket.
2 Press the 
(POWER) button to switch your
.
8 |
Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.
1 | Place your thumb on the position marked | on the battery |
compartment cover (rear of the remote control) and pull the cover in | ||
| the direction of the arrow. |
|
2 | Insert two AAA, LR03 or equivalent batteries, taking care to respect | |
| the polarities: |
|
| + on the battery against + in the battery compartment | |
| – on the battery against – in the battery compartment | |
3 | Replace the cover by sliding it back until it clicks into position. | |
|
|
|
If you will not be using the remote control for a long time, remove the batteries to prevent corrosion.
The remote control can be used up to approximately 7 meters in
astraight line. It can also be operated at a horizontal angle of up to 30° from the remote control sensor.
Connecting the Loudspeakers
The loudspeaker connector terminals are located on the rear of the system.
There are two terminals on the system:
left speaker (marked L) 
right speaker (marked R)
To achieve the correct sound quality,insert those speaker connector cables to the speaker connector terminals of the system.
8 |
6