Issues | Solutions and Explanations | |
|
| |
The Broadcasting menu is | •• The Broadcasting menu is only available when the TV source is selected. | |
grey out (unavailable). | ||
| ||
|
| |
Your settings are lost after 5 | •• If the TV is in the Store Demo mode, it will reset audio and picture settings every 5 minutes. If | |
minutes or every time the TV is | you want to change the settings from Store Demo mode to Home Use, press the SOURCE | |
turned off. | button to select TV mode, and go to MENU → Support → Use Mode. | |
|
| |
| •• Check the cable connections and reconnect them. | |
You have intermittent loss of | •• Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables | |
audio or video. | ||
are flexible enough for long term use. If mounting the TV to the wall, we recommend using cables | ||
| ||
| with 90 degree connectors. | |
|
| |
You see small particles when |
| |
you look closely at the edge of | •• This is part of the product’s design and is not a defect. | |
the frame of the TV. |
| |
|
| |
The PIP menu is not available. | •• PIP functionality is only available when you are using a HDMI or components source. | |
|
| |
You turned the TV off 45 | •• It is normal. The TV operates the OTA (Over The Aerial) function itself to upgrade firmware | |
minutes ago, and it turned on | ||
downloaded whilst your watching TV. | ||
again. | ||
| ||
|
| |
The message “Scrambled | •• If you are using a CAM CARD (CI/CI+), check that it is installed into the common interface slot. | |
Signal” or “Weak or No | •• If there is still a problem, pull the CAM CARD out of the TV and insert it into the slot again. | |
Signal” appears. | ||
|
| |
There are recurrent picture/ | •• Check and change the signal/source. | |
sound issues. | ||
| ||
|
| |
A reaction may occur between |
| |
the rubber cushion pads on the | •• To prevent this, use felt pads on any surface of the TV that comes in direct contact with furniture. | |
base stand and the top finish | ||
| ||
of some furniture. |
| |
|
| |
The message “This file may | •• This may appear because of high bit rate of content. Content generally will play but could | |
not be playable properly.” | ||
experience some playability issue. | ||
appears. | ||
| ||
|
|
✎✎ You can keep your TV in optimum operating condition by upgrading to the latest firmware (www.samsung.com → support) by USB.
✎✎ This TFT LED panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
Recommendation - EU Only
•• Hereby, Samsung Electronics, declares that this LED TV is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
•• This equipment may be operated in all EU countries.
•• The official Declaration of Conformity may be found at http://www.samsung.com, go to Support > Search Product Support and enter the model name.