HDMI Auto Detection Function
The product's video output will automatically change to HDMI mode when connecting an HDMI cable before power is on. For possible HDMI resolutions, see page 31.
•This function is not available if the HDMI cable does not support CEC.
•HDMI connection description
-HDMI outputs only a pure digital signal to the TV.
-If your TV does not support HDCP, random noise appears on the screen.
•What is the HDCP?
HDCP
!CAUTION
The Anynet+ function is supported only when an HDMI Cable is connected to the HDMI OUT of the product.
Connecting the FM Antenna
02 Connections
FM Antenna (supplied)
FM ANT
WIRELESS
iPod
DIGITAL AUDIO IN
OPTICA
1.Connect the FM antenna supplied to the FM ANT Jack.
2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.
✎NOTE
This product does not receive AM broadcasts.
Attaching the Toroidal Ferrite Core to the Speaker Cables of the Main Unit
If you attach a Toroidal ferrite core to the Speaker Cables of the man unit, it will help to prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make a loop once in the Speaker Cables.
3.Attach the Toroidal ferrite core to the Speaker Cables of the Main Unit as the figure shows and press it until it clicks.
FM ANT
WIRELESS
iPod
SPEAKER IMPEDANCE : 3