FILE #E21609
Fan Forced Wall Heaters
91 / ”
4
12 1 / ”
2
11”
4” | 10 | 3/ | ” |
|
| 8 |
|
| 1” |
|
|
Installation & Maintenance Instructions
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley Engineered Products. You have made a wise investment selecting the highest quality product in the heat- ing industry. Please carefully read the installation and maintenance directions shown in this manual. You should enjoy years of efficient heating comfort with this product from Marley Engineered Products...
the industry’s leader in design, manufacturing, quality and service.
... The Employees of
Marley Engineered Products
!WARNING 
Read Carefully - These instructions are written to help you prevent difficulties that might arise during installation
of heaters. Studying the instructions first may save you considerable time and money later. Observe the following procedures, and cut your installation time to a minimum.
To reduce risk of fire or electric shock:
1.Disconnect all power coming to heater at main service panel before wiring or servicing.
2.All wiring must be in accordance with the National and Local Electrical Codes and the heater must be grounded as a pre- caution against possible electric shock.
3.Verify the power supply voltage coming to heater matches the ratings printed on the heater nameplate before energizing.
4.This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
5.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire,or damage to the heater.
6.Do not block air intakes or exhaust in any manner. Keep com-
bustible materials, such as crates, dr | apes, etc., away from |
heater. Do not install behind doors, furniture, t | owels, or |
boxes. |
|
7.A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are stored.
8.Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
9.This heater is not approved for use in corrosive atmospheres such as marine, green house or chemical storage areas.
SAVE THESE INSTRUCTIONS
1