3.The package includes two plastics feet, which are needed when the fan is placed on a surface rather than in a window.
ⅠUSED IN A WINDOW
1. | Each side has two locks. Release the locks |
| |
| at either one side or two sides to pull out the |
| |
| extenders. | Figure 1 | |
2. | Put the locks back to fix the extender at desired length. | ||
|
ⅡUSED AT SURFACE
The fan can be used at a surface besides a window. In this situation, just snap the two plastic feet at the bottom of the fan body. No tools needed.
OPERATING INSTRUCTION
Plug it into an outlet. The red LED will display “ROOM” and two digits; this is the indoor temperature.
ⅠPANEL OPERATION
The fan has two reversible motors. The rotation speed and direction of each motor are controlled independently using panel operation.
1.SPEED CONTROL
The three speeds— low (L), medium (M) and high (H) are controlled by the left/right speed buttons and showed by relevant left/right speed lights. For example, when the light beside “L”is on, the speed is low. When you press the “ON/SPEED1/OFF” / “ON/SPEED2/OFF”button, the left/right motor starts at low speed. Press the button repeatedly to select the speed; the sequence of speed is low, medium, high and off.
2.DIRECTION CONTROL
To exhaust, press the “DIRECTION1”/“DI- RECTION2” button. Change the air direction by
pressing the button repeatedly.
Figure 2
To make the air exchange, set the two motors to rotate in opposite direction.
3.TEMPERATURE SETTING
The fan can be set at any temperature from 65℉to 90℉. Press the “TEMP”button for several seconds until the temperature LED starts blinking. Now the word “SET”shows while “ROOM” disappears. Each time you press the “TEMP+” /