Draining The Unit

During the cooling process, some water will be extracted from the air and stored within the unit’s water reservoir.

If the water reservoir is full, both the compressor and motor will stop and the unit will beep (press any button to stop the beeping sound). The full water tank indicator light will also flash.

To resume cooling, empty the water reservoir by following these steps:

1.Turn off the air conditioner and unplug it from the wall socket. To prevent water leakage, avoid moving the unit when full.

2.Place a container (such as a small pan) underneath the drainage port.

3.Remove the water plug from the drainage port and allow the water to drain out.

4.When the container is almost full, replace the water plug back into the drainage port and empty the water container.

5.Repeat until the water reservoir is completely empty.

6.Replace the water plug back into the drainage port and make sure it is firmly in

place.

FIG.20

7.Turn the unit back on. The full water tank indicator should turn off.

To operate the unit continuously without manually emptying the tank, follow these steps:

∙Remove the water plug from

the drainage port and retain it for future use.

∙ Connect the included drainage hose to the drainage port as shown. Connect the other end of the hose into a drain.

Rubber plug

Drain knob

FIG.21