Setting UP the Magnetic Code Controller

QSDL503AD USER MANUAL

Section 6: SETTING UP THE MAGNETIC CODE CONTROLLER

Arm Button – Press to set	Alarm Button – Press to
Your Magnetic Code	Instantly Activate the
Controller in Arm Mode	Alarm in the event of an
	emergency

(Picture 8)

Pressing the ARM button once on the Magnetic Code Controller will activate it after 30 seconds. After 30 seconds, the Controller is actively on and protecting the doorway that you chose to mount it on. You must deactivate the Magnetic Code Controller in order to gain access to the doorway by entering in a 4-digit Access Code.

The default Access Code on your Magnetic Code Controller is 0123. To change this number, hold down the ARM button continuously for 3 seconds until you hear a beep. Press the 4 digit code of your choice followed by the ARM button. You have now reset your Magnetic Code Controller Access Code. You must use this Access Code to deactivate your Magnetic Code Controller and to turn off the alarm in the event that the door the Controller is protecting has been opened improperly.

6 P a g e