Procom QN300RYLA Cabinet, Main Burner, Logs, Replacementparts Note, Parts Under Warranty

We also recommend that you keep						Burner
the burner tube and pilot assembly
clean and free of dust and dirt. To
clean these parts we recommend
using compressed air no greater
than 30 PSI. Your local computer
store, hardware store, or home
center may carry compressed air in
a can. You can use a vacuum
cleaner in the blow position. If
using compressed air in a can,
please follow the directions on the
can. If you don't follow directions						Figure 25-Pilot Inlet Air Hole
on the can, you could damage the
pilot		assembly.
1.	Shut off		the unit, including the
		pilot. Allow the unit to cool for				MAIN BURNER
		at least thirty minutes.
2 .	I n s p e c t		b u r n e r , p i l o t		a n d	Periodically inspect all burner flame
		primary air inlet holes on				holes with the heater running. All
		injector holder for dust and dirt				slotted burner flame holes should
		(See Figure		24).		be open with		yellow	flame	present. All
3 .		B l o w	a i r	t h r o u g h	t h e	round	burner	flame	holes	should be
		ports/slots and holes in the				o p e n	w i t h	a s m a l l b l u e f l a m e
		burner.				present. Some burner flame holes
4.		Check	the injector holder
		located at the end of the				may become blocked by debris or
		burner	tube	again. Remove		rust, with no flame present. If so,
		any large particles of dust, dirt,				turn off heater and let cool. Either
		lint, or pet hair with a soft cloth				remove blockage or replace burner.
		or vacuum cleaner nozzle.				Blocked burner flame				holes will

5.Blow air into the primary air create soot. holes on the injector holder.

6.In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4.

Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot assembly. There is a small pilot air inlet hole about two inches from where the pilot flame comes out of the pilot assembly (see Figure 25). With the unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air is not available.

Figure 26-

Figure 24 -Injector Holder on Outlet

Burner Tube

CABINET

Air Passageways

Use a vacuum cleaner or pressurized air to clean.

Exterior

Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust.

LOGS

If you remove logs for cleaning, refer to Installing Logs to properly replace logs.

Replace logs if broken or chipped (dimesized or larger).

REPLACEMENTPARTS NOTE:

Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.

PARTS UNDER WARRANTY

Contact authorized dealers of this product. If they can't supply original replacement part(s) call the number on the back of manual . when contacting your dealer or PRO-COM, have ready:

Your name
Your	address
Model	and	serial numbers
of your heater
How heater		was malfunctioning

Type of gas used (propane/LP or NG)

1 4