Napoleon Fireplaces WF 6/9/18 manual Piping Diagram with UV-LIGHT

PIPING DIAGRAM WITH UV-LIGHT

9 X

N570-0043 (8-32 X 3/4")

TO

ELECTRICAL

OUTLET

1

3

				2
				4
FROM THREE
WAY VALVE TO	FROM WATERFALL
WATERFALL	DRAIN TO BASIN
A	B
			A	FROM THREE WAY
FROM BASIN TO				VALVE TO WATERFALL
WATERFALL DRAIN
	B			FROM WATER
				SOURCE TO
INSTALL THE SUPPLIED				FLOAT VALVE
HOSE CLAMPS ON EITHER
SIDE OF THE BASIN
				SADDLE VALVE
		UV		FLOW CONTROL
OVERFLOW				VALVE / PURGE
		LIGHT	WATER	VALVE
PROTECTION
			FILTER
TO DRAIN	PURGE LINE

REMOVE COMPONENTS FROM BASIN AND ASSEMBLE AS SHOWN. THE FITTINGS REQUIRED ARE ALREADY ATTACHED TO THE FILTER AND BASIN. WHEN USING THE OPTIONAL UV-LIGHT, THE BARBED ELBOW FITTING ON THE ‘IN’ SIDE OF THE

FILTER WILL NEED TO BE REMOVED AND THREADED INTO THE ELBOW AT THE BOTTOM OF THE UV-LIGHT. THEN CON-
NECT THE UV-LIGHT DIRECTLY TO THE FILTER. USE TEFLON TAPE TO SEAL THESE CONNECTIONS. ENSURE THAT THE
SUPPLIED GROUND WIRE IS CONNECTED FROM THE GROUNDING TERMINAL ON THE UV LIGHT TO EITHER GROUNDED
COPPER PLUMBING, OR THE GROUND IN YOUR ELECTRICAL SYSTEM. USE THE SUPPLIED SHORT PIECE OF BLACK
TUBING TO RUN FROM THE PUMP TO THE UV LIGHT. MEASURE AND CUT THE LINES TO THE LENGTH NECESSARY, PUSH
ONTO THE BARBED FITTINGS AND SECURE WITH THE SUPPLIED HOSE CLAMPS. LEAK TEST THE WATERFALL BEFORE	11
FULLY ENCLOSING.