Monessen Hearth SBV500 Code Approval, Never connect unit to private, Monly known as wellhead gas

Page 4

BBV, SBV Series Natural Vent Gas Fireplaces

IMPORTANT SAFETY INFORMATION

Continued on Page 4

14.Do not use any solid fuels (wood, coal, paper, card- board, etc.) in this fireplace. Use only the gas type indicated on rating plate.

15.This appliance, when installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electri- cal Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1.

16.Do not obstruct the flow of combustion and ventilation air in any way. Provide adequate clearances around air openings into the combustion chamber along with adequate accessibility clearance for servicing and proper operation.

17.When the appliance is installed directly on carpeting, tile or other combustible material other than wood flooring, you must set appliance on a metal or wood panel or hearth pad extending the full width and depth of the appliance.

18.Do not use fireplace if any part has been exposed to or has been under water. Immediately call a quali- fied service person to arrange for replacement of the unit.

19.Do not operate fireplace if any log is broken.

20.Do not use a blower fireplace, heat exchanger fire- place or any other accessory not approved for use with this fireplace.

21.The fireplace is not intended for use with a thermo- stat.

22.This appliance must be installed with draft hood in same atmospheric pressure zone as the combustion air inlet to the appliance.

23.For Massachusetts Residents Only: This product must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massa- chusetts. Flexline installation must not exceed 36”.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY

It is not unusual for gas fireplace to give off some odor the first time it is burned. This is due to the manufactur- ing process.

Please ensure that your room is well ventilated dur- ing burn off - open all windows.

It is recommended that you burn your fireplace for at least en (10) hours the first time you use it.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY

It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.

 

WARNING

Never connect unit to private

 

 

 

 

(non-utility) gas wells. This gas is com-

 

 

monly known as wellhead gas.

 

 

 

WARNING

Proposition 65 Warning: Fuels listed in gas, wood burning or oil fired appliances, and the products of combustion of such fuels, contain chemicals known to the State of California to cause cancer, birth defects and other reproductive harm.

California Health and Safety Code Sec. 25249.6

CODE APPROVAL

These appliances have been tested by CSA and found to comply with the established standards for VENTED GAS FIREPACES in the US and Canada as follows:

LISTED VENTED GAS FIREPLACE

TESTED TO: ANSI Z21.50a-2008 CSA2.22a-2008

62D4036

Image 4
Contents Vent Series Natural Vent Gas Fireplace Product Specifications Pre-Installation InformationVenting Installation Fireplace InstallationInstaller Important Safety InformationOwner Code Approval Never connect unit to privateNon-utility gas wells. This gas is com Monly known as wellhead gasProduct Features Product SpecificationsItems Required for Installation Before YOU StartFireplace Dimensions & Framing Fireplace FramingSBV400 SBV500 Fireplace Location Clearances to CombustiblesFinishing Material Installation Planning Installation PrecautionsVent Pipe Firestops Vent InstallationTerminate the Pipe Outside Combustion AIR Combustion AIR Assembly Model OAC-4 Combustion AIR ASSEM- BLYInstallation Items Needed Installing GAS Piping to Fireplace LocationCheck GAS Type Use pipe joint sealant that is resistant to Fireplace InstallationLiquid petroleum LP gas Do not use open flame to check for gas LeaksElectrical Installation Electrical WiringRemote Wall Mounted Switch Do not connect wall switch to AC 110 V circuitRemote Wall Switch Electronic Pilot Ignition WiringOptional DC Remote Systems Final Installation Rock Wool PlacementLOG Placement Lava Rock and Ember PlacementLeak Testing Initial LightingNever use an open flame to check for gas leaks What to do if YOU Smell GASApproved Leak Testing Method Operating InstructionsLighting the Burner Main Burner SwitchPilot Position Lighting Electronic IGN BURNER, Pilot and Control Compartment Pilot FlameBurner Burner FlameLogs Vent SystemRock Wool Firebox Components Replacement Parts BBV400 SBV400 SBV500BBV, SBV Series Natural Vent Gas Fireplaces Standing Pilot Millivolt ControlFuel Conversion Kits Millivolt Natural Gas to LP Electronic Ignition Ignition Module Symptom Possible Cause Action TroubleshootingStanding Pilot Ignition Occasionally occur even though operation is normal at General Troubleshooting BBV, SBV Series Natural Vent Gas Fireplaces BBV, SBV Series Natural Vent Gas Fireplaces BBV, SBV Series Natural Vent Gas Fireplaces Carbon Monoxide Detector Requirements Lifetime Warranty Five Year WarrantyBasic Warranty If Warranty Service is NeededMhsc
Related manuals
Manual 42 pages 53.86 Kb

SBV400, BBV400, SBV500 specifications

The Monessen Hearth SBV400, SBV500, and BBV400 are premium gas fireplaces that combine elegant design with state-of-the-art technology to enhance any living space. Each model offers a unique blend of features aimed at addressing diverse heating needs while boasting impressive aesthetic appeal.

The SBV400 and SBV500 models are particularly noted for their distinctive contemporary styling. These vented gas fireplaces provide a clean and efficient heat source while serving as a stunning focal point in any room. The SBV400 delivers efficient warmth with an output of up to 32,000 BTUs, while the SBV500 impresses with a powerful maximum output of 40,000 BTUs, catering to larger spaces and providing superior heat distribution. Both models come equipped with a standard remote control, allowing you to adjust the flame height and temperature with ease, ensuring maximum comfort at your fingertips.

The technology behind these fireplaces includes a unique burner system that produces a stunning, realistic flame pattern. This advanced burner technology not only enhances the visual appeal but also promotes optimal fuel efficiency. The models are designed to utilize either natural gas or propane, offering versatility based on your needs. Additionally, an optional fan kit can be incorporated into these fireplaces to further enhance their heating capabilities, helping to circulate warm air throughout the room effectively.

In contrast, the BBV400 is designed with a more traditional aesthetic, featuring a classic fireplace look that suits a variety of décor styles. This model also boasts significant heating capabilities with a maximum output of 32,000 BTUs, ensuring warmth and comfort during colder months. Its minimalist design, combined with the variety of available face options and decorative media, allows homeowners to customize the look of their fireplace to meet their personal preferences.

All three models feature built-in safety measures, including an automatic shut-off system and an insulated firebox, ensuring peace of mind during operation. The easy-to-use control panel and optional wall switch further enhance user convenience.

Whether you choose the modern SBV series or the traditional BBV400, Monessen Hearth fireplaces are engineered to provide not only reliable performance but also an elegant addition to your home. With their exceptional features, cutting-edge technology, and stylish designs, these fireplaces are the perfect solution for anyone seeking both functionality and beauty in their heating options.