3.The access panel can be removed by taking out the 8 #10 self taping screws. A 5/16” nut driver will be required to complete this job. Unplug wires from the thermal switch on the panel. See FIGURE 15.
4.Remove the securing wingnut from the blower mounting bracket, slide the bracket to the right and rotate the left side of the assembly out of the cavity to clear the blower motor. Disconnect the two wires from the blower motor. Remove the ground wire from the blower mounting bracket, then the assembly can be taken out of the rear cavity through the access door opening.
5.Remove the 3 screws that hold the blower to the mounting bracket. Service or replace the blower as required.
| GROUND STUD | SECURING | |
|
| WINGNUT | TAB |
|
|
|
|
|
|
|
|
|
|
|
|
9
1150 BLOWER INSTALLATION
1.Remove the knock- out from the back of the fireplace.
2.Install the blow-
er and housing as shown using the 4 screws supplied.
FIGURE 19
FIGURE 16
6.Reinstall the blower assem- bly making sure the blower bracket is seated under the securing tab. FIGURE 16. Reattach the wire connectors. FIGURE 17.
7.Replace the gasket on the access door. To replace the access panel, reverse Step
3.
8.Replace the bricks into the firebox. Reinstall the door.
WIRES
FIGURE 17
3.Loosen the thermodisc bracket (2 screws) and slide the bracket forward until the thermodisc is touching the rear firebox and secure.
1150 FEATURES
FIGURE 20
1402 BLOWER SERVICE OR REPLACEMENT
1.Turn off all electrical power to the insert. Remove the glass door and set aside in a safe place.
2.Remove the two screws from the outer edge of the side panel(s).
3.Push the side panel toward the door and pull away from the insert, releasing the panel from the keyed slot.
4.Service or replace the blower(s) as required.
5.
BLOWER |
| G |
| HEAT | B |
| RHEOSTAT | |
BLOWER | SENSOR |
W
Pot
Fender
Wood
Storage
(intended for
short term use)
FIGURE 18
LID LIFTER
HOOK
Remove the screw, as illustrated, from the preferred side of the stove rear. Secure the lid lifter hook, as illustrated, facing out to the side, or bend it towards the back.