Vornado Ultrasonic Vortex Humidifier, ULTRA1 manual Getting Started How to Use Humidifier Controls

Page 5

Getting Started

How to Use Humidifier Controls

Filling Water Tank

Before initial use, you must soak the Mineral Cartridge in water for 24 hours. You may use a separate container or Water Tank to do so. If Tank is used, empty water and refill with fresh water prior to use.

Note: the unit may take several minutes to create mist with the initial use of a new Mineral Cartridge.

A

AC

BD

This Humidifier has a 2 gallon capacity and 3.5 gallon output in 24 hours (if set to High output, Continuous Humidity setting).

To fill Water Tank:

1.Unplug Humidifier. Place on firm and level surface, such as the floor.

Note: Spills can occur during cleaning, moving, or refilling Water Tank, so be careful to avoid spills when doing these activities. Do not touch the water inside the Base, as the water temperature can reach 92 degrees F.

2.Remove Water Tank by grasping recessed handle on back (A). Lift and pull outward.

3.Turn Water Tank upside down.

4.Remove Cap (B). Empty any remaining water inside Water Tank. Rinse, wipe clean and dry with clean cloth or paper towel.

5.Place Water Tank in sink with opening at the top.

6.Fill Water Tank with cool tap water (C).

7.Ensure Gasket is properly positioned and secure Cap.

8.Lower Water Tank into Base, positioning Fill Port over raised bump in Base. Once in nested position, the water outlet valve inside Cap will open, releasing water into Base.

8English

BC

Note: The rate of water dispensing from Water Tank into Base is controlled by the Mineral Cartridge. The unit may take several minutes to fill the Base.

Read and understand this owners guide before operating this product. Position unit to not blow directly on objects or plants. Plug unit into a 110-120 volt AC outlet.

Power Button (A) - turns the unit On or Off. LCD Screen will illuminate when powered On. Unit will default to Continuous Misting, Cool Mist, and High Output. Adjust settings for desired operation.

Mist Condition (B) - select Cool or Warm Mist Output. The temperature of the mist on the Warm Mist setting is approximately 94 -98 degrees at the Outlet. However, the mist will feel much cooler to the touch, because it is immediately entrained in the Vortex beam of air generated by the fan.

Humidity (C) - sets desired humidity level. Press Humidity Button until desired humidification level is illuminated. The unit will operate until the desired humidity level is reached, at this point, the mist output will turn Off. The humidity level indicator light will remain on. If the mist output does not turn on, the set humidity level may be lower than the room humidity level. Increase the humidity set point until the mist turns on. This is an indication of the level of humidity already

in the room. If moisture forms on walls or windows, lower humidity settings or turn Off Humidifier.

AUTO 1 Continuous misting, cool mist, low fan speed. AUTO 2 Continuous misting, warm mist, high fan speed

40% - 60% Humidity level. Manually set Mist Condition and Fan Speed.

Fan Speed (D) - select desired Fan Speed - High or Low .

High - operation for fast humidification for larger rooms. High speed operation will evaporate 3.5 gallons of water (+/- 10%) in 24 hours of continuous operation. (This assumes room conditions of 70º F and 30% relative humidity.)

Low - operation for quiet, nighttime use or smaller rooms. On Low operation, your Humidifier may run without refilling for extended periods.

Notifications

Refill Tank - Notifies you when the Water Tank needs to be refilled. Will automatically turn off after it has been refilled.

Clean Unit - Displays after 400 hours of operation. It is recommended to clean your Humidifier at this time (see CLEANING INSTRUCTIONS). To reset notification, press and hold the Power Button for 3 seconds. Replace the Mineral Cartridge - Displays after 800 hours of operation. It is recommended to replace the Mineral Cartridge at this time

(see REPLACING MINERAL CARTRIDGE for instructions). To reset notification, press and hold the Power Button for 3 seconds.

English 9

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Ultrasonic Vortex Humidifier Owner’s Guide Contents Vornado Difference TrustProduct Information Notifications Getting Started How to Use Humidifier ControlsFilling Water Tank Mineral Cartridge Replacement Cleaning and MaintenanceCleaning Instructions Automatic Refill Program Operating Tips and Recommendations TroubleshootingStorage Para revisar si hay fugas Contenido¿No se observan fugas? ¿Hay fugas?Cordialmente Bill Phillips CEO, Vornado Air La Confianza La Diferencia VornadoInformación Sobre El Producto Llenado del tanque de agua Inicio Cómo Utilizar Los Controles Del HumidificadorPara llenar el tanque de agua NotificacionesInstrucciones para la limpieza Limpieza y MantenimientoReemplazo del cartucho de minerales Cómo cambiarloAlmacenamiento Consejos y recomendaciones para el funcionamientoPour détecter les fuites Table Des MatièresAucune fuite? Il y a des fuites?La Confiance La Différence Vornado Instructions ImportantesInformations Sur Le Produit Remplissage du réservoir deau Pour Démarrer Utilisation Des Commandes De LhumidificateurPour remplir le réservoir deau AvisNettoyage et Entretien Remplacement de la cartouche minéraleInstructions de nettoyage Pour désinfecterRangement Conseils et Recommandations Quant À L’utilisation DépannagePage Vornado Air, LLC

Ultrasonic Vortex Humidifier, ULTRA1 specifications

The Vornado Ultrasonic Vortex Humidifier, model ULTRA1, is a cutting-edge solution for maintaining optimal indoor humidity levels. Designed to enhance your living space, this humidifier combines advanced ultrasonics technology with innovative vortex action to deliver a seamless and efficient humidification experience.

One of the standout features of the Vornado ULTRA1 is its ultrasonic technology. This method uses high-frequency vibrations to transform water into a fine mist, which is then distributed evenly throughout the room. The result is a more comfortable environment that helps alleviate dry skin, chapped lips, and other issues caused by low humidity.

The ULTRA1 is equipped with a unique vortex action that circulates the humidified air, ensuring that every corner of the room benefits from the added moisture. Unlike traditional humidifiers that simply release mist into the air, the Vornado’s vortex technology allows for a more comprehensive coverage, reaching up to 1,000 square feet. This makes it an ideal choice for larger spaces, such as living rooms, offices, and even small apartments.

Another notable characteristic of the Vornado ULTRA1 is its adjustable humidity control. Users can easily customize their humidity levels with the integrated digital display and controls. The built-in humidistat monitors the room's humidity and adjusts the output accordingly. This feature not only maintains a comfortable atmosphere but also improves energy efficiency by preventing over-humidification.

The ULTRA1 is also designed for user convenience and ease of maintenance. It features a large, easy-to-fill water tank that can hold up to 1.5 gallons, allowing for extended operation without constant refilling. Additionally, the tank is equipped with a carry handle for simple transport and cleaning.

Another important aspect is the Whisper Quiet operation, which ensures that the humidifier won’t disturb your peace. This makes it perfect for bedrooms, nurseries, or any quiet space.

With its stylish design, advanced features, and powerful humidification capabilities, the Vornado Ultrasonic Vortex Humidifier ULTRA1 stands out as a top choice for those seeking relief from dry air and a healthier home environment. It embodies a combination of technology, efficiency, and user-friendly design, making it an essential addition to any household. In a world where indoor air quality matters more than ever, the ULTRA1 provides an effective solution.
Top Page Image Contents