Teledyne manual Appendix B GFC7000EU Spare Parts List

MODEL GFC7000EU CO ANALYZER WITH AUTO-REFERENCE

(Addendum to GFC7000E Manual PN 04584)

Warning	Fault Condition		Possible Causes
Message
	on wheel rotation.		Failed Sync/Demod Board
		If Status LED’s on the Sync/Demod Board ARE
		flashing the cause is most likely an a problem with
		the analyzer’s main power:
			Intermittent loss of the power supply too short
			to cause a SYSTEM RESET warning;
			Frequency problem with the AC Mains.
SYSTEM RESET	The computer has	This message occurs at power on.
	rebooted.	If it is confirmed that power has not been
		interrupted:
		 Failed +5 VDC power,
			Fatal Error caused software to restart
			Loose connector/wiring
WHEEL TEMP	The filter wheel		Blocked Cooling Vents below GFC Assembly
WARNING	temperature is		Analyzer’s Top Cover removed
	controlled at 68 ± 5		Wheel Heater
	°C		Wheel Temperature Sensor
			Relay controlling the Wheel Heater
			Entire Relay Board
			I2C Bus

APPENDIX B – GFC7000EU Spare Parts List

NOTE

Use of replacement parts other than those supplied by API may result in

non-compliance with European standard EN 61010-1.

Table B-1: GFC7000EU Individual Spare Parts List

	Part	Description
Number
000941000		CD, Orifice, 13 mil
003291500		Assy, Thermistor, Bench Wheel, M300E
006110200		Assembly, Motor Wheel Heater, 50W 120V
009550500		Source Assembly (with Adapter)
009600400		M300E 47 mm Filter Expendables Kit - KNF Pump Model
		7	05134 Rev -