Jwin JX-CD2100 Connecting the Speakers, AC Operation, Antennas, Listening with Stereo Headphones

Mini Portable Stereo Audio System V10M10_IM_EN_12172007

GETTING STARTED

Connecting the Speakers

Connect the SPEAKER cables to the SPEAKER terminals in the rear of the unit properly.

AC Operation

Before operating this unit, make sure the voltage indicated on the JX-CD2100 matches the voltage in the wall outlet.

1.Plug the AC POWER CORD into a standard AC wall outlet.

2.The STANDBY/MUTE INDICATOR will light.

3.Press the POWER button. The LCD DISPLAY will light and the STANDBY/ MUTE INDICATOR will go off.

Antennas

For best FM reception, fully extend the FM antenna. For AM reception, this unit has a built-in antenna.

Listening with Stereo Headphones

For private listening, insert the 3.5mm plug of a stereo headphone set (not included) into the STEREO HEADPHONE JACK on the left side panel of the

JX-CD2100. Volume on the headphones is controlled by the VOLUME knob on the unit of the VOLUME -/+button on the remote control. When headphones are used, sound on the external speakers cuts off.

Note: Be sure that your headphones have an impedance of 32ohms.

Installing Batteries in the Remote Control

1.Slide open the BATTERY DOOR in the direction of the arrow imprinted on the door itself.

2.Install two (2) AA size batteries according to the polarity (+/-) marked inside the compartment

3.Close the BATTERY DOOR.

Note: Remote Control buttons correspond with the similarly labeled buttons on the main unit. The recommended distance for remote operation is 16 feet or less.

- 8 -www.jWIN.com