Sunbeam 2576 owner manual Troubleshooting Checklist, Condition What to Check What to do

TROUBLESHOOTING CHECKLIST

Many times questions that appear to be major can be solved quite easily. The chart below lists potential questions/ problems and how to correct them. Remember, check the simple things first.

CONDITION				WHAT TO CHECK			WHAT TO DO
Unit fails to turn on.		1.		Power Cord		1.	Plug in power cord.
		2.		Electrical	Outlet	2.	Check for power to the electrical outlet.
							Plug a table lamp into the electrical outlet
							to ensure power availability.
		3.		ON/OFF	Switch	3.	Set ON/OFF Switch to desired speed.
			4. Cabinet Top is properly			4.	Refer to section on previous page,
				intalled			“To Replace Cabinet Top.”
			5. Collector		assembly is pro-	5.	Use directions on the top side of the
				perly installed.			assembly. Aluminum Pre-Filter will face the front
							grill.
						1. As the HEPA Filter collects, a higher speed
Unit does not			HEPA Filter
remove	pollutants/						may be necessary to maintain the original
Reduced	air flow						cleaning level of the air cleaner.
						2. The HEPA Filter needs to be replaced. (Will
							need to be replaced every 12 months or
							sooner depending on the environment the
							air cleaner is operated in.)
Unit still does not			Re-check the above points.			Return unit to Appliance Service Station,
operate	properly.					Hattiesburg, MS, for service. See
						Warranty Information on back cover
						for address.

NOTE:

Blowing smoke directly into the front grill is not a good test for unit performance.

4