Magnadyne EAX540 manual Precautions for Handling Discs, With new discs

Page 4

PRECAUTIONS FOR HANDLING DISCS

With new discs

The symptoms described below

 

sometimes occur when new discs

 

are used:

 

• The disc is not played even

Burrs

when it is loaded.

Center

• Operation changes to the next

disc before the first disc has a

Burrs hole

chance to be played.

Outside

• The same disc is played over

circmference

and over again.

 

• The designated disc is not

 

played.

 

These symptoms occur when there are burrs on the center hole or outside circumference of the disc and, as a result, the disc has not been loaded properly or the disc catches on something inside the magazine. In cases like these remove the burrs using a ball point pen or similar implement, as shown in the figure on the right.

Remove all plastic particles of burr from surfaces of disc before loading in magazine.

WARNING

Although protective film is being marketed as CD accessories, use of these products will result in malfunctions and should absolutely be avoided.

4

Image 4
Contents Installation Operations Manual Contents Hints for Correct and Safe OperationInstalling the magazine HOW to USE the MagazineLoading a disc Precautions for Handling Discs With new discsWiring Installation PartsReset Function Installation and Wiring Precautions Transport Lock ScrewsPosition of the built-in anti-vibration board Installation Procedure for Installation on Carpet Horizontal PositionProcedure for Installation on Carpet Vertical Position Procedure for Installation on Carpet at a 45 angle Procedure for Installation Suspended Position Troubleshooting Handling the Discs