Magnadyne EAX540 manual Procedure for Installation on Carpet Vertical Position

Procedure for Installation on Carpet (Vertical Position)

1

•Set that the built-in anti-vibration boards on both the left and right sides are set to the vertical installation position “90”.

•Attach the left and right brackets (A) using the hexagonal bolt (M4 x 5).

•Attach the left and right brackets (A) to their respective brackets (B) using the hexagonal bolts (M6 x 12) and the hexagonal nuts (M6).

Built-in anti-vibration board position

Hexagon bolts (M6 x 12)

Hexagonal bolts

(M4 x 5)

2	•	Pull back the carpet and determine	3	• Remove the hexagonal nuts and
		where to attach the unit.		take off the changer.
	•	Stick the supplied double-sided
		tape to the bottom of the brackets
		(B) and peel off the paper backing.
	•	Affix the unit to the floor by pressing
		in place.

4	•	Using a knife, cut “X”s in the carpet	5	• Once more, use the hexagonal nuts
		directly above the brackets (B) bolts.		to attach the changer on top of the
	•	Return the carpet to its original		carpet.
		position allowing the bolts to stick
		through.

9