press the buttons, you set the volume between the val- ues
•To change the volume of the subwoofer: Press the SW + button to increase the volume. Press the SW – button to lower the volume. Each time you press the buttons, you set the volume between the values
8.3.Setting the bass and the treble
You can change the intensity of the low tones (bass) and the high tones (treble) during sound playback. To increase the intensity of the bass, press the BASS + button.
To decrease the intensity of the bass, press the BASS - but- ton. Each time you press the buttons, you set the intensity of the bass between the values
To increase the intensity of the high tones, press the TRE- BLE + button. To reduce the intensity of the high tones, press the TREBLE – button. Each time you press the but- tons, you set the intensity of the high tones between the values
8.4. Setting the speaker balance
To adapt the sound playback to the conditions of the room, you can set the speaker balance. With this, you can shift the sound from the front speaker to the left or right speakers.
To shift the sound to the left speaker, press the BALANCE.L button. To shift the sound to the right speaker, press the BALANCE.R button. Each time you press the buttons, you set a value between 00 and 15. The currently set value is shown briefly in the display of the center speaker.
Press the BALANCE button on the remote control,
to cancel the shift of the sound to the left/right hand side. 0 will be shown briefly in the display of the center speaker.
8.5.Switching the surround sound system to mute
To switch the sound playback to mute with the loudspeak- ers of the surround sound system: Press the MUTE button on the remote control once. STANDBY/MUTE will be shown in the display of the center speaker and the currently set volume will flash.
To switch the sound playback back on again, press the MUTE button again. STANDBY/MUTE will disappear in the display of the center speaker.
9.Cleaning the surround sound system
Clean the casings of the components only with a slightly damp cloth and a mild detergent. Pay attention that when cleaning, no moisture gets inside the components! In par- ticular, never immerse the components of the surround sound system into water!
Attention!
If moisture penetrates into the components or if water runs into it, then this can cause irreparable damage!
Warning!
In this case, there is additionally also a fire risk!
10.Rectifying Malfunctions
10.1.The remote control does not work
Possible causes:
AHave the batteries in the remote control been put into the battery compartment with the correct polarity?
BAre the batteries in the remote control exhausted? If necessary change both batteries.
CAre there any obstacles between remote control and center speakers?
DHave you moved more than 5 meters away from the center speaker when using the remote control?
10.2. No sound
Possible causes:
AIs the surround sound system – as described in chapter 6 – ready for operation?
BHas the surround sound system been switched to mute by pressing the MUTE button?
CAre all the cable connections between
•the speakers and the subwoofer
•the subwoofer and audio/video devices connected to it correct? Have all plugs been inserted firmly into the respective jacks?
DHas the volume of audio/video devices, which have
been connected to the surround sound system, been set loud enough?
EHave the audio/video devices, which are connected to the surround sound system, been switched to mute?
12 | KH 2222 |