Empire Products RH-50-6 Safety Information for Users of LP-GAS, LP-GAS Warning Odor

Page 4

SAFETY INFORMATION FOR USERS OF LP-GAS

Propane (LP-Gas) is a flammable gas which can cause fires and explosions. In its natural state, propane is odorless and colorless. You may not know all the following safety precau- tions which can protect both you and your family from an ac- cident. Read them carefully now, then review them point by

point with the members of your household. Someday, when there may not be a minute to lose, everyone’s safety will de- pend on knowing exactly what to do. If, after reading the fol- lowing information, you feel you still need more information, please contact your gas supplier.

LP-GAS WARNING ODOR

If a gas leak happens, you should be able to smell the gas because of the odorant put in the LP-Gas.

That’s your signal to go into immediate action!

Do not operate electric switches, light matches, use your phone. Do not do anything that could ignite the gas.

Get everyone out of the building vehicle, trailer, or area. Do that IMMEDIATELY.

Close all gas tank or cylinder supply valves.

LP-Gas is heavier than air and may settle in low areas such as basements. When you have reason to suspect a gas leak, keep out of basements and other low areas. Stay out until firefighters declare them to be safe.

Use your neighbor’s phone and call a trained LP-Gas service person and the fire department. Even though you may not continue to smell gas, do not turn on the gas again. Do not re-enter the building, vehicle, trailer, or area.

Finally, let the service man and firefighters check for escaped gas. Have them air out the area before you return. Properly trained LP-Gas service people should repair the leak, then check and relight the gas appliance for you.

NO ODOR DETECTED - ODOR FADE

Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. You must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor. Sometimes other odors in the area mask the gas odor. People may not smell the gas odor or their minds are on something else. Thinking about smelling a gas odor can make it easier to smell.

The odorant in LP-gas is colorless, and it can fade under some circumstances. For example, if there is an underground leak, the movement of the gas through soil can filter the odorant. Odorants in LP-gas also are subject to oxidation. This fading can occur if

there is rust inside the storage tank or in iron gas pipes.

The odorant in escaped gas can adsorb or absorb onto or into walls, masonry and other materials and fabrics in a room. That will take some of the odorant out of the gas, reducing its odor intensity.

LP-gas may stratify in a closed area, and the odor intensity could vary at different levels. Since it is heavier than air, there may be more odor at lower levels. Always be sensitive to the slightest gas odor. If you detect any odor, treat it as a serious leak. Immedi- ately go into action as instructed earlier.

SOME POINTS TO REMEMBER

Learn to recognize the odor of LP-gas. Your local LP-Gas Dealer can give you a “Scratch and Sniff” pamphlet. Use it to find out what the propane odor smells like. If you suspect that your LP-gas has a weak or abnormal odor, call your LP- gas dealer.

If you are not qualified, do not light pilot lights, perform service, or make adjustments to appliances on the LP-gas system. If you are qualified, consciously think about the odor of LP-gas prior to and while lighting pilot lights or performing service or making adjustments.

Sometimes a basement or a closed-up house has a musty smell that can cover up the LP-gas odor. Do not try to light pilot lights, perform service, or make adjustments in an area where the conditions are such that you may not detect the odor if there has been a leak of LP-gas.

Odor fade, due to oxidation by rust or adsorption on walls of new cylinders and tanks, is possible. Therefore, people should be particularly alert and careful when new tanks or cylinders are placed in service. Odor fade can occur in new tanks, or reinstalled old tanks, if they are filled and allowed to set too

long before refilling. Cylinders and tanks which have been out of service for a time may develop internal rust which will cause odor fade. If such conditions are suspected to exist, a periodic sniff test of the gas is advisable. If you have any question about the gas odor, call your LP-gas dealer. A periodic sniff test of the LP-gas is a good safety measure under any condition.

If, at any time, you do not smell the LP-gas odorant and you think you should, assume you have a leak. Then take the same immediate action recommended above for the occasion when you do detect the odorized LP-gas.

If you experience a complete “gas out,” (the container is un- der no vapor pressure), turn the tank valve off immediately. If the container valve is left on, the container may draw in some air though openings such as pilot light orifices. If this occurs, some new internal rusting could occur. If the valve is left open, then treat the container as a new tank. Always be sure your container is under vapor pressure by turning it off at the container before it goes completely empty or having it refilled before it is completely empty.

12822-3-0406

Page 4

Image 4
Contents Installation Instructions Table of Contents Important Safety Information This is a Heating ApplianceSafety Information for Users of LP-GAS LP-GAS Warning OdorSpecifications IntroductionInstalling a New Main Gas Cock GAS SupplyRecommended Gas Pipe Diameter Checking Manifold PressureVenting ClearancesLiner and Insulated Liner Vent Safety Shutoff System Thermostat OperationLighting Instructions fireTechnician. Force or attempted repair may result in a fire Or explosionPilot Flame Characteristics Main Burner Flame CharacteristicsPrimary Air Adjustment see On Propane gas, if a whistling noise resonation occursMaintenance TroubleshootingHOW to Order Repair Parts Parts List RH-50 & RH-65Parts View RH-50 & RH-65 Parts List RH-50C & RH-65C Index Part Description NumberParts View RH-50C & RH-65C Optional Blower Installation Instructions Wiring Wiring DiagramFan Control OilingService Notes Service Notes Service Notes

RH-50-6 specifications

The Empire Products RH-50-6 is a cutting-edge heating solution designed to provide efficient warmth and comfort in residential and commercial settings. Known for its robust construction and high-performance features, the RH-50-6 has become a popular choice among consumers looking for reliability and efficiency in heating.

One of the standout characteristics of the Empire RH-50-6 is its impressive heating capacity. With a powerful output designed to warm larger areas, this unit is ideal for spaces such as living rooms, basements, or even commercial environments. The RH-50-6 utilizes an advanced heating technology known as radiant heat, which warms objects and surfaces in the room directly, providing a consistent and comfortable temperature throughout the space.

Another key feature of the RH-50-6 is its sleek design. The modern aesthetics are complemented by a user-friendly interface, making it easy for homeowners to control their heating experience. The unit comes equipped with a digital thermostat that enables precise temperature regulation, allowing users to set their desired level of comfort with ease. Additionally, the thermostat can be programmed to maintain specific temperatures at different times of the day, optimizing energy usage and enhancing convenience.

The Empire RH-50-6 also prioritizes safety, equipped with several built-in safety features, including an automatic shut-off mechanism that activates if the unit overheats. This ensures peace of mind for users, particularly in family environments. The unit is designed to operate quietly, contributing to a serene atmosphere while maintaining warmth without disruptive noise levels.

Moreover, the Empire Products RH-50-6 emphasizes energy efficiency. The innovative design minimizes energy consumption while maximizing output, aligning with modern environmental standards and helping users reduce their utility bills. This eco-friendly characteristic makes it an attractive choice for those who are conscious of their environmental impact.

In summary, the Empire Products RH-50-6 stands out for its combination of powerful performance, user-friendly technology, and safety features. Whether for a large home or a commercial space, its ability to provide efficient and consistent heating is a testament to Empire’s commitment to quality and innovation. The RH-50-6 is not just a heating solution; it represents a blend of style, efficiency, and comfort that consumers can trust.