FIREPLACE MANUFACTURERS INC.
UNVENTED NATURAL GAS LOG HEATER
OPERATING
HEATER
Continued
IMPORTANT: This remote control has been specially engineered to take an air temperature sample every 5.5 minutes in the auto mode. It will not respond immediately to the tempera- ture setting being turned up or down.
IMPORTANT: The
3.To turn the burner off, press the AUTO/ON/OFF button until OFF lights. The pilot will remain lit.
IMPORTANT: To turn the pilot off, manually turn the control knob on the heater to the OFF position.
INSPECTING
BURNERS
Check pilot flame pattern and burner flame patterns often.
PILOT FLAME PATTERN
Figure 25 shows a correct pilot flame pat- tern. Figure 26 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.
If pilot flame pattern is incorrect, as shown in Figure 26
•turn heater off (see To Turn Off Gas to Appliance, page 15)
•see Troubleshooting, pages 18 through 20
Pilot Burner
Thermocouple
Figure 25 - Correct Pilot Flame Pattern
Pilot Burner
Thermocouple
Figure 26 - Incorrect Pilot Flame Pattern
Control Knob in | Flame Adjustment Knob | ||||
On Position |
| ||||
|
|
|
| OL |
|
N |
|
| O |
|
|
O |
| F |
|
| |
|
|
|
| ||
T | F |
| HI | ON | |
|
| ||||
OLIP |
|
|
| ||
|
|
|
|
| OFF |
|
|
|
|
| REMOTE |
|
|
|
| Selector Switch in | |
|
|
|
| Remote Position | |
Figure 23 - Setting the Remote Selector Switch, Control Knob, and Flame Adjustment Knob for Remote Operation
| Increases Room | |
Shows | Temperature in | |
AUTO Mode | ||
Temperature | ||
| ||
Setting | Decreases Room | |
| ||
The Log Heater | Temperature in | |
AUTO Mode | ||
will Automatically | ||
| ||
Cycle between | Turns Burners | |
Pilot and the Heat | ||
On or Off and | ||
Setting that has | ||
Allows You to | ||
been Selected | ||
Choose the Auto | ||
| ||
| Setting |
Figure 24 - Thermostat Hand-Held Remote Control Unit Selections (GHRCTA Series Only)
16 | 105072 |