ILLUSTRATION
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your
A
M
N
O
K L
F G HP
Holmes table fan. Please remember:
•Always unplug the fan before cleaning or disassembling.
•Do not allow water to drip on or into the fan motor housing.
•Do not use any of the following as a cleaner: gasoline, thinner, benzine
(See instructions for fan head assembly)
B C D EIQ
J
A.Grill Hub
B.Screw
C. Washer | R | |
D. Grill Ring |
| |
E. | Front Grill | S |
F. | Blade Nut | |
G.Blade
H.Rear Grill
I.Metal Plate
J. Rear Grill | O. | Motor Housing |
K. Motor Shaft | P. | Pole |
L. Motor Housing Prong | Q. | Speed Control Lever |
M. Handle | R. | Base |
N. Oscillation Knob | S. | Base Nut |
Step 1: To access the fan blade, remove the front grill and the fan blade nut.
Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution.
Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill.
Fan Head and Base Cleaning
Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.
OPERATING INSTRUCTIONS
Step 1: Set the fan base on a dry, level surface.
Step 2: Please make sure the On/Speed lever is in the "Off" position. Plug the cord into any standard
Step 3: The SPEED is adjusted by moving the lever up or down to the desired setting.
Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up.
FAN STORAGE
Your fan can be stored in the
•If stored disassembled, we recommend using the original (or appropriately sized) box.
•If stored assembled or partially assembled, remember to protect the fan head from dust.
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
To change the tilting angle of the fan head, move the fan head to the desired angle.