Scotsman Ice user manual C1448, C1848, C2148W Drains, Follow all applicable codes

C1448, C1848, C2148W

Air and Water Cooled User Manual

Drains

All models require drain tubing to be attached to them. Air cooled models have a single ¾” FPT drain fitting in the back of the cabinet. Water cooled models have the same fitting plus an additional ½” FPT drain fitting in the back of the cabinet.

Install new tubing when replacing a prior ice machine, as the tubing will have been sized for the old model and might not be correct for this one.

1 Connect water supply to water inlet fittings.

Note: This NSF listed model has a 1" anti-back flow air gap between the end of the water inlet tube and the highest possible reservoir water level, no back flow device is required for the potable water inlet.

2 Connect drain tubing to drain fittings.

3Route the drain tubing to building drain. Follow local codes for air gap.

Use rigid drain tubes and then route them separately – do not Tee into the bin’s drain or, if water cooled, Tee the condenser drain into the reservoir or bin drain.

Vent the reservoir drain. A vertical vent at the back of the drain, extended about 8 – 10” will allow the gravity drain to empty and also keep any surges during draining from discharging water.

Horizontal runs of drain tubing need a ¼” per fall per foot of run for proper draining.

Follow all applicable codes.

Water Inlet Connection

Potable Water Supply

Optional Water Filters

Floor Drain

Water Cooled

Condenser

Inlet

Reservoir

Drain

Water Cooled

Condenser

Drain

Water Supply and Drain Connections

November 2006

Page 11