HEARTH PRODUCTS KITS AND ACCESSORIES
P/N
REFLECTIONS TELEVISION REPLACEMENT KIT
INSTALLATION INSTRUCTIONS FOR THE REFLECTIONS ELECTRIC FIREPLACE
TELEVISION REPLACEMENT KIT (NUMBER: H6963)
REPLACEMENT INSTRUCTIONS
Removal Of The Existing TV From The Reflections Electric Fireplace
Step 1. Disconnect the electrical power to the fireplace.
Step 2. Remove the doors from the fireplace.
Step 3. See Figure 1 for the location of the door track and remove it. Keep the two (2) door clips and screws to be used again upon re- assembly.
Door |
Track |
Figure 1 |
Step 4. Remove the reflective glass. To access the logs, grate embers and lights, the glass panel needs to be removed. For an illustration of the glass panel installation, (refer to Figure 8, on page 4 ).
First sweep the screens inward and tie up and out of the way. The glass is not secured by any fasteners. The back rests on two insulated tabs and the front is hooked behind a lip.
CAUTION: WHEN REMOVING THE GLASS, DO NOT LET THE BACK OF THE PANEL SLIP OFF OF THE INSULATED TABS IN THE BACK. THIS COULD ALLOW THE GLASS TO DROP INTO THE REFRACTORY PANELS OR LOGS AND BREAK THEM.
The lower front corners of the glass are exposed to provide a place to grip the glass panel. Grip the corners firmly; lift the panel back and up against the top of the unit.
Disengage the glass from behind the front lip and rotate the front upwards. Slide one hand under the glass and support the panel. Draw the glass out of the unit and set it carefully aside.
Glass Information
•This unit will not operate properly with missing or broken glass.
•Do not strike or slam the glass.
•Do not use abrasive cleaners to clean the glass.
•This appliance uses tempered glass. Replacement of the glass as supplied by the manufacturer should be done by a qualified service technician.
Step 5. Remove the Logs.
Step 6. Remove the Grate.
Step 7. Remove the Ember Bed.
Step 8. Disconnect and label the video and audio cables from the TV and remove the IR module.
Step 9. Locate the two locking screws that secure the television assembly and remove them (see Figure 2 ).
Latch
Rod 
Figure 2 | Locking Screw |
|
Step 10. Press upwards on the latching rods to free the television assembly. Once free, the assembly will rotate down to a vertical position hanging from the screen rods (refer to Figure 3 ).
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.