Screen Rod
Power Cord
Detail Of
Top Receptacle
Tabs |
|
Engagement Hooks | Top Receptacle |
Hand Holds |
Figure 3
CAUTION: THE TELEVISION ASSEMBLY IS HEAVY. PLEASE CLEAR THE AREA IN FRONT OF THE FIREPLACE BEFORE ATTEMPTING TO SWING THE UNIT INTO POSITION. THE UNIT MUST SWING SLIGHTLY PAST HORIZONTAL TO LATCH. WE SUGGEST THAT TWO PEOPLE PERFORM THIS STEP.
Step 11. Lift the assembly upwards to free it from the screen rods.
Step 12. Lay the television tray assembly onto a flat surface. Use a cardboard protector to protect the tray from marring.
Step 13. Undo the straps to remove the existing TV.
INSALLING THE REPLACEMENT TV
Step 1. Open the television box and remove all packing materials from the unit. Remove the television and place it beside the tray.
Note: The Television is provided with a remote control. The fireplace does not require this remote control. It may be discarded.
Drape the straps to the side of the tray assembly, out of the way as much as possible.
The television will lay face down on the tray as shown in Figure 4. The television is oriented centrally on the tray with the bottom against the base support. The straps are then doubled over the unit as shown in Figure 4 and drawn very taut. Cross strap both sides tightly (with straps provided inside carton support package) to prevent the television from slipping out of position.
Note: The TV screen protrudes below the bottom frame of the tray assembly. Be sure to support the tray assembly above the work surface to protect the TV screen. Use the spacers from the TV box to do this.
Lift the assembly up onto its base (as shown in Figure 3 ) and verify the security of the straps. Use the handles on each side of the unit to
lift and hold the unit.
CAUTION: THE SECURITY OF THE STRAPS IN THIS ASSEMBLY IS IMPORTANT SO THAT THE INSTALLATION STEPS THAT FOLLOW CAN BE PERFORMED SAFELY.
Television |
| |
(Face Down) |
| |
Tray | Television | |
Straps | ||
Assembly | ||
| ||
Use | Spacers | |
Center Slot |
| |
| Secure Television | |
| Straps Tightly | |
Cross |
| |
Strap |
| |
Handles | Television | |
Base | ||
| Base Support | |
Figure 4 |
|
2
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.