Trane XL manual Problem Solver, Extra Energy Tips, Insulation, Heating, Cooling

Page 5

The Problem Solver

Before you call for service, check the following:

Problem

Possible cause

Remedy

Insufficient heating

a. dirty filters

a. clean or replace

or cooling

b. air not circulating

b. check supply registers and

 

freely

return grills for blockage

 

c. blocked outdoor coil

c. clear away leaves or other

 

 

debris

 

 

 

Failure to operate

a. power off

a. make sure main switch is

 

 

in ON position

 

b. open circuit breaker

b. reset circuit breaker, or

 

or burned-out fuses

replace burned-out fuses

 

c. improperly adjusted

c. check setting, adjust

 

thermostat

thermostat

 

 

 

No Heating or

Blower door removed

Close door securely to

Cooling – Blower

or ajar

restore power to blower

does not operate

 

 

 

 

 

Unusual Noise

 

Call your local servicer

 

 

 

Reduce the burden of unexpected repair bills with a Trane Extended Warranty.

Trane offers the finest quality products and manufacturer’s warranties on the market. But, like all good things, the Trane- provided limited warranty on your new comfort equipment will come to an end. To keep you protected, Trane offers the Extended Warranty Program. It picks up right where your Trane limited warranty leaves off. And, it offers years and years of reliable protection at a low cost. Ask your dealer for program details.

The Trane Extended Warranty provides:

1.The opportunity to supplement your Limited Warranty for five or ten years.

2.Coverage that may include parts only or parts and labor for the duration of the agreement. Be certain you read the Extended Warranty for complete details and exclusions.

3.Service work performed by servicers knowledgeable of the operation of Trane equipment.

Extra Energy Tips

Insulation

1.Make sure your home is properly insulated. This is the single most important step in conserving energy. Thermal insulation should be specified in terms of thermal resistance (R-values). R-30 (10") is recommended for ceilings, R-11 (3-1/2) for exterior walls and floors over unheated areas. In colder climates, consider additional insulation.

2.Infiltration of humid outside air is your heating and cooling system’s worst enemy — it could account for 15 to 30% of air conditioning energy requirements. Find the places where air can sneak into the home and plug them with caulking, weather- stripping or plastic. Also, weather- strip and caulk around all entrance doors and windows.

3.Cut heat transfer through your windows by 40 to 50% with double glazing (two panes of glass separ- ated by a sealed air space) and low-e glass.

4.Use wood- or metal-frame storm windows even if single-glazed windows are high quality. The extra layer of glass and the layer

of still air will cut heat transfer considerably.

5.Install storm doors at all entrances to your house.

6.Keep all windows and doors closed.

7.Remember that by increasing the glass area, you increase the amount of heat added in summer and lost in winter.

8.Make sure fireplaces have tight- fitting dampers which can be closed when the fireplace is not in use.

9.Invest in a humidifier to conserve energy in winter. The air in your home won’t be as dry, so you stay comfortable at a lower temperature setting.

Heating

10.Locate the thermostat on an inside wall away from windows and doors.

11.Set the thermostat as low as comfort permits. Each degree over 68°F can add 3% to the amount of energy needed for heating.

12.People generate heat. So lower the thermostat a degree or two when expecting a large group of guests.

Cooling

13.Set the thermostat as high as comfort will permit.

14.Make sure attics are adequately ventilated to relieve heat buildup. If necessary, improve air flow by adding or enlarging vents.

15.When building a new house or renovating an old one, choose light-colored roof shingles to reflect more of the sun’s heat.

16.During moderate weather, don’t use the air conditioner unnecessarily.

17.Draw blinds or drapes to block the sunlight during the hottest part of the day.

18.Install awnings over windows exposed to direct sunlight.

19.In the cooling season, don’t run kitchen and bath exhaust fans longer than necessary.

20.Don’t place lamps, TV sets or other heat producing devices beneath a wall-mounted thermostat. Rising heat from the equipment may cause the air conditioner system to over cool your house.

22-5194-01-0701 (EN)

5

Image 5
Contents XL Series Central Air Conditioning Use and CareContents How it works to keep you comfortable Proper maintenance for maximum efficiencyHow to remove your filter How to operate your system for peak performance Proper maintenanceExtra Energy Tips Problem SolverInsulation HeatingService Information Important Service Information

XL specifications

The Trane XL series represents a pinnacle of HVAC technology, designed to provide homeowners with comfort, efficiency, and reliability. These units are particularly known for their exceptional performance and innovative features that stand out in the market. Trane's reputation for quality is complemented by cutting-edge technology and user-centric design.

One of the main features of the Trane XL series is its energy efficiency. Many models in this line boast a SEER (Seasonal Energy Efficiency Ratio) rating of up to 22, which significantly reduces energy consumption compared to older systems. This efficiency not only lowers utility bills but also contributes to environmental sustainability. The units utilize advanced variable-speed technology, allowing the compressor to adjust its speed to meet the heating or cooling demands of the home precisely. This feature ensures consistent comfort levels while minimizing energy waste.

The Trane XL series is equipped with a durable construction designed to withstand harsh weather conditions. The units often come with a weather-resistant cabinet, which has been rigorously tested for longevity and reliability. Additionally, the use of high-quality components, such as the Spine Fin™ coil and DuraTuff™ polyester powder paint, enhances the durability and performance of the units.

In terms of technology, the Trane XL series utilizes the ComfortLink II™ communicating technology. This system enables seamless communication between the thermostat and the HVAC equipment, optimizing performance and efficiency. Homeowners can control their HVAC system remotely through a mobile app, making it easy to adjust settings and monitor performance from anywhere.

Moreover, the XL series features noise reduction technology, including a sound-dampening design and variable-speed fans. As a result, these systems operate quietly, providing a comfortable environment without intrusive noise.

Regardless of the model chosen, customers can expect a robust warranty and excellent customer support from Trane, reflecting their commitment to quality and customer satisfaction. With a blend of efficiency, advanced technology, and durable construction, the Trane XL series continues to be a preferred choice for homeowners looking for a reliable and efficient HVAC solution.